Sanyo PLC-XU 101K owner manual Auto PC button

Basic Operation

AUTO PC button

Press the AUTO PC button on the remote control to operate the Auto PC function.

For more detail, see 28.

D.ZOOM buttons

Press the D.ZOOM buttons on the remote control to zoom in and zoom out the images.

For more detail, see 34.

NO SHOW button

Press the NO SHOW button on the remote control to black out the image. To restore to normal, press the NO SHOW button again or press any other button. When a projected image is captured and set as “User” in the Logo selection (p.43), the screen changes each time you press the NO SHOW button as follows.

black out ➜ the captured image ➜ normal ➜ • • • • •

IMAGE button

Press the IMAGE button on the remote control to select a desired image level of the screen.

For more detail, see p31, 38.

P-TIMER button

Press the P-TIMER button on the remote control. The timer display “00 : 00” will appear on the screen and the timer will start to count time (00 : 00 ~ 59 : 59).

To stop the P-Timer, press the P-TIMER button. Press the P-TIMER button again, then the P-timer display will disappear.

LAMP CONTROL button

Press the LAMP CONTROL button on the remote control to select the lamp mode for changing the brightness of the screen.

Auto	brightness according with the input signal
High	brighter than the Normal mode
Normal	normal brightness
Eco	lower brightness reduces the lamp
	power consumption and extends the
	lamp life.

Remote Control

Volume +/-
buttons	POINT ed
(See p23)
	buttons
AUTO PC
button	IMAGE button
D.ZOOM
	P-TIMER button
buttons
NO SHOW
button	LAMP CONTROL
	button
✔Note:

•See the previous page for the other buttons.

The message will disappear after 4 seconds.

P-Timer display

25