Sanyo PLC-XU 101K owner manual Appendix, Some displays are not seen during the operation

Appendix

Some displays are not seen during the operation.

–Check the Display function. (See page 42.)

PIN code dialog box appears at start-up.–PIN code lock is being set. Input a PIN code (1234 or numbers you have set). (See pages 19 and 48.)

The Remote Control does not work.

–Check the batteries.

–Make sure no obstruction is between the projector and remote control.

–Make sure you are not too far from the projector when using the remote control. Maximum operating range is 16.4’ (5m).

–Make sure the code of the remote control is conformed to the projector. (See page 47.)

–Unlock Key lock for the remote control in the Key lock function. (See page 47.)

WARNING :

High voltages are used to operate this projector. Do not attempt to open the cabinet.

If problems still persist after following all operating instructions, contact the dealer where you purchased the projector or the service center. Give the model number and explain about the problem. We will advise you how to obtain service.

The CE Mark is a Directive conformity mark of the European Community (EC).

This symbol on the nameplate means the product is Listed by Underwriters Laboratories Inc. It is designed and manufactured to meet rigid U.L. safety standards against risk of fire, casualty and electrical hazards.

Pixelworks ICs used.

57