Preparation
Remote Control CH | Radio Frequency |
|
|
CH 1 ✽ | 2.472 GHz |
|
|
CH 2 | 2.403 GHz |
|
|
CH 3 | 2.446 GHz |
|
|
CH 4 | 2.421GHz |
|
|
Channel switches sequentially for one pressing the SELECT button.
Remote Control ID
ID 1 ✽
ID 2
ID 3
ID 4
ID switches sequentially for one pressing the SELECT button.
Preparation
Table1: Remote Control Channel & Frequency
✽Default setting
ID 5
ID 6
ID 7
ID 8
Table2: Remote Control ID
Caution about Radio Wave
The remote control operates in 2.4 GHz band, the same frequency band used for industrial, scientific, and medical equipment (such as pacemaker), as well as amateur radio stations.
Before operating the remote control, make sure no electromagnetic interference occurs and pay attention to the following cautions.
1.Be sure that there are no other devices in the area that may use the same frequency band as the remote control.
2.If any other devices are causing radio interferences, change the communication frequency channel or move to other location.
Caution in Wireless LAN Interference
Under wireless LAN environment based on IEEE 802.11b and IEEE802.11g, the remote control may not operate properly due to radio interferences. The remote control is initially set to use 2.472 GHz band (CH1) corresponding to several channels of wireless LAN.
Should the remote control not operate properly due to radio interference, switch the communication frequency channel to CH2. Yet the operating condition is not improved, try CH3 and CH4. In case of failure in every channel operation, relocate other radio equipment using 2.4 GHz band away from the remote control and the projector.
Remote Control Battery Installation
1 | Open the battery | 2 | Install new batteries | 3 | Replace the compartment |
compartment lid. | into the compartment. | lid. | |||
|
|
| Two | AA size alkaline |
|
Press the lid downward | batteries | |
and slide it. | ||
For correct polarity (+ and | ||
| ||
| ||
| are in contact with pins in | |
| the compartment. |
To insure safe operation, please observe the following precautions: ● Use (2) AA or LR6 type alkaline batteries.
● Always replace the batteries in sets.
●Do not use a new battery with a used battery.
●Avoid contact with water or liquid.
●Do not expose the remote control to moisture, or heat.
●Do not drop the remote control.
●If a battery has leaked on remote control, carefully wipe case clean and install new batteries.
●Risk of explosion if battery is replaced by an incorrect type.
●Dispose of used batteries according to the instructions.
17