Safety Instructions
Air Circulation
Openings in the cabinet are provided for ventilation and to ensure reliable operation of the product and to protect it from overheating, and these openings must not be blocked or covered.
CAUTION
Hot air is exhausted from the exhaust vent. When using or installing the projector, the following precautions should be taken.
–Do not put any flammable objects or spray can near the projector. Hot air is exhausted from ventilation holes.
–Keep the exhaust vent at least 3.3’ (1m) away from any objects.
–Do not touch a peripheral part of the exhaust vent, especially screws and metallic part. This area will become hot while the projector is being used.
–Do not put anything on the cabinet. The materials put on the cabinet will not only get damaged but also cause fire hazard by heat.
Cooling fans are provided to cool down the projector. The fan's running speed is chaged according to the temperature inside the projector.
Exhaust Vent (Hot air exhaust)
Air Intake Vent
Setup In Proper Directions
Use the projector properly in specified positions. Improper positioning may reduce the lamp life and result in severe accident or fire hazard.
This projector is allowed to project the picture in any position of 360 degrees such as upward, downward, or backward as below.
Bottom | Front | Bottom | Front |
Downward | Upward | Upward | Downward |
(Usual) |
|
|
|
Positioning Precautions
When installing the projector, avoid positioning it as described below:
20˚
Do not tilt the projector more than 20 degrees from side to side.
20˚
Do not put the projector on either side to project an image.
In upward projection, do not tilt the projector over 20 degrees right and left.
In downward projection, do not tilt the projector over 20 degrees right and left.
6