Installation
Connection Terminals
Terminals for connecting the AC power cord and other equipment are located in the front part of the projector for easy setup. The terminal area is covered with a front cover to protect from dust and others, and hide messy cable connections.
Remove and replace the front cover by following the procedure below:
To remove the front cover, push the button A on right side of the front cover and pull the cover forward.
To put back the front cover to the projector, insert the left part of the cover into the projector and then push the entire cover. Make sure that the front cover is locked with the button A and fitted on the projector.
Caution
Do not push the front cover hard or subject it to excessive shock. Doing so may damage the cover.
Front cover
A
Pull this part forward by pushing button A.
Terminals
Installation
Interface Board Slots
The projector's front terminal area has two replaceable Interface board slots. The projector's functions can be extended by installing the optional interface boards into the terminal slots. Two vacant slots (Input 4 and Input 5) are provid in your purchasing the projector.
Install or replace the optional interface boards as follows:
Remove two (2) screws and uncover the slot.
Insert an interface board into the slot along with the guides inside to fit the socket into the inside plug. Secure the board with the two (2) screws.
✔Note:
When installing or removing the interface board, disconnect the AC power cord from the AC outlet before doing it.
✔Notes On Ordering or Using Optional Interface Boards:
When ordering or using the Optional Interface Boards, contact your sales dealer and tell the Model no. of your desired board (p.73) and Option Control No. shown in the Information menu. (p.30, 59)
Socket
Optional interfae board
Screws
Option Control No.
06
See Option Control No. in the Information menu to order any optional interface board.
21