Sanyo PLC-ZM5000L owner manual Direct on, Pointer, Timer, 18000, Count up or Count down

Setting

Direct on

When this function is set to On, the projector will be automatically turned on just by connecting the AC power cord to the wall outlet.

Note:

Be sure to turn off the projector properly (see “Turning Off the Projector” on page 24). If the projector is turned off in the incorrect sequence, the Direct on function does not work properly.

Pointer

You can emphasize a part of the projected image with this function. Use the Point ▲▼ buttons to select a pattern of the Pointer (Dot, Arrow or Finger). (p.32)

P-timer

This function allows you to change the presentation of the P-timer and execute it.

Select one of the following options:

Count up	The P-timer display 000:00 appears on
	the screen and the count starts (000:00–
	180:00)
Count down	The time set in the Timer setting appears
	on the screen and the countdown starts.
Timer	Use the Point ▲▼ buttons to set the
	Timer (1–180 Min). Only set to Count
	down, Timer is active. Factory default
	value is 10 Min.
Start	It executes the count up or count down
	function. Press the SELECT button at
	Start, Start changes to Stop in the
	Screen Menu. At that time, press the
	SELECT button at Stop to stop Count
	up or Count down, and Stop changes
	to Restart in the Screen Menu. Press
	the SELECT button at Restart to resume
	Count up or Count down.
Reset	Reset the P-timer values.
	Press the SELECT button at Reset to
	return to the following value;
	Count up	"000:00"
	Count down ... Timer that you set.
Exit	To exit the P-timer operation.

Stop or Cancel the P-timer via Remote Control

To stop the P-timer, press the P-TIMER button.

To cancel the P-timer, press and hold the P-TIMER button for a few seconds.

P-TIMER

P-timer display.

60