Sanyo PLC-ZM5000L owner manual Appendix

Appendix

	– Filter is out of scroll. Replace the filter cartridge with a new one promptly. (See
	pages 67-68)
appears on the screen
	– Adjust the focus of the projector.
	– Check Projection Lens to see if it needs cleaning.
The image is out of	Note: Moving the projector from a cool temperature location to a warm temperature
	location may result in moisture condensation on Projection Lens. In such
focus..
	cases, leave the projector OFF and wait until condensation evaporates.
	–  Projecting from excessive slant angle to the screen may cause keystone distortion
	and partial imperfect focus.
	– Check if Contrast or Brightness is adjusted properly. (See pages 41, 47)
The image is not	– Check if Image level is selected properly. (See pages 40, 46)
	– Check the Lamp control function. ( See “Setting” section on page 57)
bright enough..
	– Check the LAMP REPLACE indicator. If it lights, the end of lamp life is approaching.
	Replace the lamp with a new one promptly. (See page 69)
The color is strange..	– Check the Input signal, color system, video system, or computer system mode.
	– Adjust the Image Level properly. (See pages 40, 46)
The image is Left/	– Check the Ceiling / Rear function. (See pages 44, 50)
Right reversed..
The image is Top/	– Check the Ceiling function. (See pages 44, 50)
Bottom reversed..
The image is distorted	– Check PC adjust Menu or Screen Menu and adjust them.
or runs off..
Auto PC adjustment	– Check the Input signal. Auto PC Adjustment function cannot work when 480p, 575p,
function does not	720p, 480i, 575i, 1035i, 1080i or 1080p is selected or when the digital signal is input
work.	into HDMI or DVI-D terminal. See page 37.
Some displays are
not seen during the	– Check the Display function. (see page 52)
operation..
The setting does not	– Make sure you selected Store after adjusting settings. Some settings cannot be
remain after turning
	stored if not registered with Store function.
off power..
Power management	– Power management function cannot work while Freeze function is running or the
function does not
	shutter is closed.
work..
Image disappears	– Check the power management function in the Setting. The power management is set
automatically..	to On at the factory.
Capture function does	– Check the connection to see if there is signal.
	– Capture function is not available when the Picture in Picture function is set to
not work..	User1-5.
Some menus cannot	– Each of the Video Input and Computer Input has a limit on selectable menus.
be selected..
	– Check the audio cable connection from audio input source.
	– Adjust the audio source.
No sound	– Press the Volume + button. ( See page 28)
	– Press the Mute button. (See page 28)
	– Is the image projected? You will hear the sound only when the image is projected.
	– Check the Build-in SP function. (See page 28)

74