JBL CVPD50, CVR700 manual Clean only with a dry cloth, Use only with the cart, Periods of time

read first! Important Safety Precautions!

1.Read these instructions.

2.Keep these instructions.

3.Heed all warnings.

4.Follow all instructions.

5.Do not use this apparatus near water.

6.Clean only with a dry cloth.

7.Do not block any ventilation openings. Install in accordance with the manufac- turer’s instructions.

8.Do not install near any heat sources such as radiators, heat registers, stoves or other apparatus (including amplifiers) that produce heat.

9.Do not defeat the safety purpose of the polarized or grounding-type plug.

A polarized plug has two blades with one wider than the other. A grounding-type plug has two blades and a third ground- ing prong. The wide blade or the third prong are provided for your safety. If the provided plug does not fit into your out- let, consult an electrician for replacement of the obsolete outlet.

10.Protect the power cord from being walked on or pinched, particularly at plugs, convenience receptacles and the point where they exit from the apparatus.

11.Only use attachments/accessories specified by the manufacturer.

12.Use only with the cart,

stand, tripod, bracket or table specified by the manu- facturer or sold with the apparatus. When a cart is used,

use caution when moving the cart/appa- ratus combination to avoid injury from tip-over.

intended to operate from battery power, or other sources, refer to the operating instructions.

17.If an outside antenna or cable system is connected to the product, be sure the antenna or cable system is grounded so as to provide some protection against voltage surges and built-up static charges. Article 810 of the National Electrical Code, ANSI/NFPA 70, provides information with regard to proper ground- ing of the mast and supporting structure, grounding of the lead-in wire to an antenna discharge unit, size of grounding conductors, location of antenna-dis- charge unit, connection to grounding electrodes, and requirements for the grounding electrode. See Figure A.

18.An outside antenna system should not be located in the vicinity of overhead power lines or other electric light or power circuits, or where it can fall into such power lines or circuits. When installing an outside antenna system, extreme care should be taken to keep from touching such power lines or circuits, as contact with them might be fatal.

19.Do not overload wall outlets, exten- sion cords, or integral convenience recep- tacles, as this can result in a risk of fire or electric shock.

20.Never push objects of any kind into this product through openings, as they may touch dangerous voltage points or short-out parts that could result in a fire or electric shock. Never spill liquid of any kind on the product.

21.The apparatus shall not be exposed to dripping or splashing, and no objects filled with liquids, such as vases, shall be placed on the apparatus.

22.Do not attempt to service this product yourself, as opening or removing covers may expose you to dangerous voltage or other hazards. Refer all servicing to quali- fied service personnel.

23.When replacement parts are required, be sure the service technician has used replacement parts specified by the manufacturer or that have the same characteristics as the original part. Unauthorized substitutions may result in fire, electric shock or other hazards.

24.Upon completion of any service or repairs to this product, ask the service technician to perform safety checks to determine that the product is in proper operating condition.

25.The product should be mounted to a wall or ceiling only as recommended by the manufacturer.

	13. Unplug this apparatus during light-
	ning storms or when unused for long
	periods of time.
	14. Refer all servicing to qualified serv-
	ice personnel. Servicing is required when
	the apparatus has been damaged in any
	way, such as power-supply cord or plug
	is damaged, liquid has been spilled or
	objects have fallen into the apparatus,
	the apparatus has been exposed to rain
	or moisture, does not operate normally,
	or has been dropped.
	15. Do not use attachments not recom-
	mended by the product manufacturer, as
	they may cause hazards.
	16. This product should be operated only
	from the type of power source indicated
	on the marking label. If you are not sure
	of the type of power supply to your
	home, consult your product dealer or
4	local power company. For products

Figure A.

Example of Antenna Grounding as per

National Electrical Code ANSI/NFPA 70

Antenna Lead-In Wire

Ground Clamp

Antenna Discharge Unit (NEC Section 810-20)

Grounding Conductors (NEC Section 810-21)

Electric Service Equipment

Ground Clamps

Power Service Grounding Electrode System

(NEC Art. 250, Part H)

Part No. HCGUL1492/6500 04/2004 EN