Power Connection and Operator Control
The CVPD50 plasma display and the CVR700 are completely disconnected from electrical power only when the power cables are removed from both units and/or the wall outlets, and the JBL Digital Link™ cable connecting the CVR700 to CVPD50 is unplugged. Only connect the CVPD50 plasma display and the CVR700 to a plug receptacle that has been installed in compliance with local regulations regarding proper grounding, and which provides 120V. Make sure that the power plug and outlet are accessible at all times.
Use only the power cord supplied with the CVPD50 plasma display. Never remove the plug from the outlet by pulling on the cable. Do not run the power cord near
If you will be away for an extended period of time, it is a good idea to unplug the units and any antennae. It is also a good idea to do the same before any thunder- storms. This is a precautionary measure to prevent the possibility of personal injury or death due to fire or electric shock resulting from a lightning strike, and to prevent damage to the unit.
Always power off all units and unplug them before connecting them to each other.
Failure to follow this instruction may result in personal injury due to elec- trical shock or fire, and/or irrepara- ble damage to the unit that is not covered under warranty.
The CVPD50 plasma display is equipped with an attached glass filter plate. If the unit is exposed to excessive stress, e.g. due to shock, vibration, bending or heat, the glass surface can break. Do not sub- ject the glass surface to any pressure or knocks. If the glass is cracked, unplug the power cord immediately. Do not touch the fragments with your bare hands. Failure
to follow these instructions may result in personal injury due to
Always make sure that two people lift the CVPD50 plasma display together. Never attempt to lift the unit by yourself.
Failure to follow this instruction may result in personal injury or irrepara- ble damage to the unit that is not covered under warranty.
9