Hitachi CP-S210 Remote Control, Putting Batteries, Remove Battery cover, Insert Batteries

Page 12

Remote Control

Putting Batteries

CAUTION Always handle the batteries with care and use them only as directed. Improper use may result in battery cracking or leakage, which could result in fire, injury and/or pollution of the surrounding environment.

Keep the battery away from children and pets.

Be sure to use only the batteries specified for use with the remote control. Do not mix new batteries with used ones.

When inserting batteries, verify that the plus and minus terminals are aligned correctly (as indicated in the remote control).

When you dispose the battery, you should obey the law in the relative area or country.

Remove the

1 battery cover.

Slide back and remove the battery cover in the direction of the arrow.

Insert the

2 batteries.

Align and insert the two

AAbatteries according to their plus and minus terminals (as indicated in the remote control).

Close the

3 battery cover.

Replace the battery cover in the direction of the arrow and snap it back into place.

12

Image 12
Contents Projector CP-S210W/CP-S210WT/CP-S210WFContents Projector Features PreparationPart Names Fastening The Lens CapInput button Power indicator Temp indicator ProjectorRemote Control Setting Up ArrangementAdjusting The Projectors Elevator Adjust the height of the projector byAs necessary, you can also finely Twisting the elevator feet by handConnecting Your Devices AUDIO-L AUDIO-R ScartConnecting Power Supply Firmly plug the power cord’s plug 1 into the outletRemote Control Remove Battery coverClose Battery cover Putting BatteriesOperating The Remote Control Power ON/OFF Turning On The PowerWhen the lens cap is attached, remove Set the power switch to onSelecting An Input Signal Turning Off The Power Switch the power switch to O OFFAttached the lens cap Adjusting The Volume OperatingTemporarily Muting The Sound Adjusting The Position Use Buttons to adjust PositionPress the Position button Using The Automatic Adjustment Feature Correcting Keystone DistortionsUsing The Magnify Feature Use Buttons to adjust the zoom LevelFreezing The Screen Press the Magnify on buttonSignal Searching Selecting The Aspect RatioTemporarily Blanking The Screen Multifunctional Settings Using The Menu FunctionsMain Menu Picture 1 Menu Load/Save a Setting Reset the PICTURE-1 Menu ItemsPicture 1 Menu MY MemoryPhase Picture 2 MenuPosition SizeInput Menu VideoFrame Lock 3D-YCSInput Menu Video NRInformation S2-ASPECTAdjust Auto MenuSearch Screen Menu Start UPMessage Option Menu Screen TypeLamp Time Lamp Replacing The Lamp Air Filter Caring For The Air FilterReplacing The Air Filter New air filter. Tell the dealer your airHold the release buttons of the air Filter, while pulling down itCaring For The Cabinet And Remote Control Other CareCaring For The Inside Of The Projector Caring For The LensTroubleshooting Related MessagesRelated Messages Regarding The Indicator Lamps Power Lamp TempRegarding The Indicator Lamps IndicatorPhenomena That May Easily Be Mistaken For Machine Defects Warranty And After-Service Phenomena That May Easily Be Mistaken For Machine DefectsSpecifications SpecificationRGB Input Ports Audio Ports Video Input PortsTechnical Signal Connectors TechnicalExample Of Computer Signal Resolution FH kHz FV Hz Rating Signal mode DisplayVesa Text VesaInitial Set Signals Mac 13modeConnecting The Cable Communications SettingRS-232C Communication Requesting projector status Get command Changing the projector settings Set commandUsing the projector default settings Reset Command Increasing the projector setting value Increment commandCommand Data Chart 4A D2日本語 Be EF FE D7 Be EF EC D9 Auto RGB Middle Be EF High Turn on Be EF