Hitachi CP-S210T Turning Off The Power, Switch the power switch to O OFF, Attached the lens cap

Page 16

Power ON/OFF (continued)

Turning Off The Power

NOTE • Turn the power on/off in right order. Please power on the projector before the connected devices. Power off the projector after the connected devices.

1 Press the STANDBY/ON button of the projector or the button of the remote control.

The message “Power off?” will appear on the screen for approximately 5 seconds.

2 Press the STANDBY/ON button again while “Power off?” the message is visible.

The projector lamp will go off, and the POWER indicator will begin blinking orange.

Then the POWER indicator will stop blinking and light to solid orange when the lamp cooling is complete.

POWER indicator

TEMP

POWERLAMP

STANDBY/ON INPUT

STANDBY/ON button

3 Switch the power switch to [O] (OFF).

Power switch (OFF position)
The POWER indicator will go off.	Power switch

(STANDBY/ON) button

4 Attached the lens cap.

VIDEO	RGB SEARCH
ASPECT	AUTO BLANK
MAGNIFY	VOLUME
	ON

Image 16

Contents Projector CP-S210W/CP-S210WT/CP-S210WFContents Projector Features PreparationPart Names Fastening The Lens CapInput button Power indicator Temp indicator ProjectorRemote Control Setting Up ArrangementAdjusting The Projectors Elevator Adjust the height of the projector byAs necessary, you can also finely Twisting the elevator feet by handConnecting Your Devices AUDIO-L AUDIO-R ScartConnecting Power Supply Firmly plug the power cord’s plug 1 into the outletRemote Control Remove Battery coverClose Battery cover Putting BatteriesOperating The Remote Control Power ON/OFF Turning On The PowerWhen the lens cap is attached, remove Set the power switch to onSelecting An Input Signal Switch the power switch to O OFF Turning Off The PowerAttached the lens cap Operating Adjusting The VolumeTemporarily Muting The Sound Use Buttons to adjust Position Adjusting The PositionPress the Position button Using The Automatic Adjustment Feature Correcting Keystone DistortionsUsing The Magnify Feature Use Buttons to adjust the zoom LevelFreezing The Screen Press the Magnify on buttonSelecting The Aspect Ratio Signal SearchingTemporarily Blanking The Screen Multifunctional Settings Using The Menu FunctionsMain Menu Picture 1 Menu Load/Save a Setting Reset the PICTURE-1 Menu ItemsPicture 1 Menu MY MemoryPhase Picture 2 MenuPosition SizeInput Menu VideoFrame Lock 3D-YCSInput Menu Video NRInformation S2-ASPECTAuto Menu AdjustSearch Start UP Screen MenuMessage Screen Type Option MenuLamp Time Lamp Replacing The Lamp Air Filter Caring For The Air FilterReplacing The Air Filter New air filter. Tell the dealer your airHold the release buttons of the air Filter, while pulling down itCaring For The Cabinet And Remote Control Other CareCaring For The Inside Of The Projector Caring For The LensTroubleshooting Related MessagesRelated Messages Regarding The Indicator Lamps Power Lamp TempRegarding The Indicator Lamps IndicatorPhenomena That May Easily Be Mistaken For Machine Defects Warranty And After-Service Phenomena That May Easily Be Mistaken For Machine DefectsSpecifications SpecificationRGB Input Ports Audio Ports Video Input PortsTechnical Signal Connectors TechnicalExample Of Computer Signal Resolution FH kHz FV Hz Rating Signal mode DisplayVesa Text VesaInitial Set Signals Mac 13modeCommunications Setting Connecting The CableRS-232C Communication Requesting projector status Get command Changing the projector settings Set commandUsing the projector default settings Reset Command Increasing the projector setting value Increment commandCommand Data Chart 4A D2日本語 Be EF FE D7 Be EF EC D9 Auto RGB Middle Be EF High Turn on Be EF