Hitachi CP-X306, CP-X206 user manual Option menu, Auto Search, Auto on

OPTION menu

OPTION menu

From the OPTION menu, items shown in the table below can be performed.

Select an item using the ▲/▼ cursor buttons, and press the ► cursor button or ENTER button to execute the item, except for the items LAMP TIME and FILTER TIME. Then perform it according to the following table.

Item

Description

	Using the ▲/▼ buttons turns on/off the automatic signal search function.
	TURN ON  TURN OFF
	When the TURN ON is selected, detecting no signal automatically
	cycles through input ports in the following order. The search is
AUTO SEARCH	started from the current port. Then when an input is found, the
	projector will stop searching and display the image.
	COMPUTER IN1  COMPUTER IN2
	VIDEO  S-VIDEO  COMPONENT
	(Y, Cb/Pb, Cr/Pr)
	Using the ▲/▼ buttons turns on/off the automatic keystone function.
	TURN ON  TURN OFF

	TURN ON : Automatic keystone distortion correction will be
	executed whenever changing the slant of the projector.
AUTO	TURN OFF : This function is disabled. Please execute the AUTO
KEYSTONE	KEYSTONE EXECUTE in the SETUP Menu for automatic
	keystone distortion correction.

•When the projector is suspended from the ceiling this feature will not function properly so select the TURN OFF.

•This function will be unavailable when the Transition Detector is on (50).

	Using the ▲/▼ buttons turns on/off the AUTO ON function.
	TURN ON  TURN OFF
	When set to the TURN ON, the lamp in projector will be
	automatically turned on without the usual procedure (15), only
AUTO ON	when the projector is supplied with the power after the power was
	cut while the lamp was on.

•This function does not work as long as the power has been supplied to the projector while the lamp is off.

•After turning the lamp on by the AUTO ON function, if neither input nor operation is detected for about 30 minutes, the projector is turned off, even though the AUTO OFF function (42) is disabled.

(continued on next page)

41