Hitachi CP-S860W user manual Lamp, Message table, Cleaning the air filter with a vacuum cleaner

Page 32

Cleaning the Air filter (continued)

3

Cleaning the air filter with a vacuum cleaner

4

Installing the air filter

Caution When the air filter becomes clogged with dust, etc., the projector power may turn off to prevent the internal heat level rising.

Do not operate the projector with the air filter removed.

Lamp

The light source lamp has a service life.

When used for an extended time, the images may become darker and the colors may deteriorate.

A malfunction could occur if the projector is used in this condition, so replace the lamp with a new one.

The following indicator or a message which appears when the power is turned on will indicate when the lamp should be replaced.

At such time, it is necessary to replace the lamp with a new one. For lamp replacement, please contact your dealer or service company.

Caution

The indicator lamp will also light red when the lamp unit overheats. In such case, turn off the

 

main power switch, wait for a while (approx. 20 min.) and then turn the power on again. If the

 

indicator lamp lights red again when the power is turned on, contact your dealer or service

 

company.

 

 

Message table

Screen displays

The following messages are displayed on the screen.

CHANGE THE LAMP"CALL

The total lamp usage time is nearing the service life of the lamp. Replace whith a new lamp.

A MAINTENANCE PERSON"

The lamp will turn off automatically when the lamp replacement time has been exceeded. *1

"CHANGE THE LAMP"

The total lamp time is nearing the lamp replacement time. After (*) hours, the lamp will turn

"CALL

off. Quickly replace with a new lamp. *1

A MAINTENANCE PERSON"

*Indicates the number of hours until the lamp turns off automatically.

"THE POWER WILL

 

TURN OFF AFTER * Hr."

 

 

 

Blinking of

The total lamp time has exceeded the replacement time. The lamp will blink for

"CHANGE THE LAMP"

approximately 10 min. and then turn off automatically. Replace with a new lamp.

 

 

NO INPUT IS DETECTED

There is no signal input (refer to pages 22, 23).

 

 

 

SYNC IS OUT OF RANGE

The current horizontal or vertical frequency cannot be used by this projector (refer to pages 23, 24).

 

 

 

*1 This display will disappear after 3min. but will reappear when the power is turned on again.

32

Page 31 Page 33
Image 32
Page 31 Page 33
Contents Outline FeaturesContentsPage Page Before Use If a problem should occur Do not install on an unstable surfaceDo not look through the lens when the lamp is on Use only the indicated power supplyDo not allow the laser beam to enter the eyes Handle the power cord with careDo not position the power Care and maintenance Battery usageClean the projector interior once every two years Avoid installation in humid or dusty locationsSound volume Avoid excessively hot locationsLens care Cabinet careChecking the package Contents Names and functions of each partMain power switch AC in jackVideo in jack RGB in jackRemote control transmitter Disk PAD1Remove the battery cover 3Close the battery cover2Loading the batteries Make sure the plus and minus poles are correctly orientedInstallation Typical LCD Projector and Screen InstallationUsing the adjusters Top view Side viewBasic operations To projectTurning off the power Turn off the main power switch of the projector OFFPlug & Play Press the STANDBY/ON button for approximately 1 secCancelling the Freeze function Freeze function will be cancelledFreeze function Press the Freeze buttonMagnify function Changing the magnification ratioMoving the display area Returning to normal displayAdjustments and functions Returning to the initial settingsPress the Menu Menu screen will appear. refer to page 18-21 for detailsUsing the Setup Menu Input RGBKeystone BlankLanguage TimerCommunication functions, etc., can be set from the OPT menu Connection to the video signal terminals Connection to the RGB signal terminalInput signals Signal input jacksConnection to the RGB signal terminal Example of computer signalConnection to the RGB signal terminal Initial set signalsConnecting the USB Connection to the control signal terminal Mouse functionsSerial mouse Control signal jackADB Mac mouse RS232C communication Command data chart System VideoRequesting projector status Example of system setup Cleaning the Air filterPull out the power cord Remove the front air filter Clean the air filter about every 100 hoursCleaning the air filter with a vacuum cleaner Installing the air filterLamp Message tableWhen you think something wrong IndicatorsSpecifications Dimensional Diagram· These specifications are subject to change without notice Cannot be used in any other countryRepairs after the warranty period has elapsed About the warranty and after-serviceAbout the warranty QR41821 Kurzbeschreibung MerkmaleInhaltSeite ModellPage Vor der Inbetriebnahme Warnung VorsichtBei Auftreten von Betriebsstörungen Nicht auf unstabilen Flächen aufstellenNiemals das Gehäuse öffnen Nicht modifizierenNur mit der korrekten Netzspannung betreiben Das Netzkabel vorsichtig handhabenKann zu Bränden oder elektrischen Schlägen führen Betreiben Sie den Projektor ausschließlichDie Belüftungsöffnungen nicht blockieren Wartung und PflegeBatteriebetrieb Den Projektor alle zwei Jahre innen säubern lassenWenn der Projektor längere Zeit nicht benutzt wird Transport des ProjektorsÜbermäßig heiße Plätze vermeiden LautstärkeProjektor Überprüfung des LieferumfangsBezeichnung und Funktion der Teile Vorsicht Anschluß an die Netzeingangsbuchse AC Magnify Mouse RESET/RIGHTFernbedienungsteil 3Den Batteriefachdeckel wieder anbringen 1Den Batteriefachdeckel 2Einlegen der Batterien AbnehmenVorsicht Vorsichtsmaßregeln für den Batteriebetrieb Aufstellung Typische Aufstellung von LCD-Projektor und LeinwandVerwendung der Fußversteller AufsichtGrundlegende Bedienung Projizieren von BildernDie Taste Standby / on drücken Das angeschlossene Gerät einschaltenGrundlegende Bedienung Fortsetzung Ausschalten der NetzversorgungDie FREEZE-Funktion wird aufgehoben Festhalten-FunktionAufheben der FREEZE-Funktion Vergrößerungsfunktion Ändern des VergrößerungsverhältnissesVerschieben des Anzeigebereichs Zurückstellen auf normale AnzeigeEinstellungen und Funktionen Rückstellung auf die AnfangseinstellungenDas Menübild erscheint Einzelheiten siehe Seite Der gewählte Menügegenstand erscheint jetzt grünVerwendung des Einrichten-Menüs Setup Einstellungen und Funktionen FortsetzungFH horizontale Sync-Frequenz BILD-IN-BILD TrapezStarten Sync EIN G SpracheAUTOM-AUS Eingangssignale SignaleingängeAnschluß an die Video-Eingangsbuchsen Anschluß an die RGB-BuchseBeispiel eines Computersignals Anschluß an die RGB-Buchse FortsetzungAnfangseinstellungssignale Computer/Signal Horizontale Signalsteuerung µsAnschluß der USB-Maus Durchlesen Anschluß an die SteuersignalbuchseMausfunktionen Serienmaus Steuersignalbuchse ControlADB-Maus Mac Anschluß an die Steuersignalbuchse Fortsetzung RS232C-DatenaustauschBefehlsdatentabelle Wenn in Datenübertragungsblockfehler auftritt Systemübersicht Beispiel Reinigen des LuftfiltersDen Luftfilter etwa alle 100 Betriebsstunden säubern Filter Modell LuftfilterReinigen des Luftfilters Fortsetzung LampeMeldungstabelle BildschirmanzeigenAnzeigen Abhilfe bei ProblemenMeldungstabelle Fortsetzung Einheit mm AbmessungsdiagrammNicht in anderen Ländern verwendet werden Garantie und Kundendienst Zur GarantieZum Kundendienst Reparaturen während der GarantiezeitQR41821

CP-S860W specifications

The Hitachi CP-S860W is a high-performance projector designed to deliver exceptional image quality, making it an ideal choice for a variety of settings, including classrooms, corporate environments, and large venues. With its advanced features and cutting-edge technologies, the CP-S860W stands out as a reliable and versatile projection solution.

One of the key features of the Hitachi CP-S860W is its high brightness output, providing up to 6,500 lumens. This brightness capability ensures that images remain clear and vibrant even in well-lit environments, making it suitable for presentations and lectures where ambient light cannot be fully controlled. The projector's native WXGA resolution (1280 x 800 pixels) enhances image clarity, allowing for detailed visuals that are essential for displaying graphs, charts, and other data-heavy content.

The CP-S860W incorporates advanced image processing technologies, such as a built-in scaler and various color enhancement features. These technologies enable the projector to deliver a rich color palette and sharp detail, ensuring that images maintain fidelity and color accuracy. Additionally, it supports multiple resolutions, allowing users to project content from various devices without loss in quality.

Another notable characteristic of the CP-S860W is its versatile connectivity options. The projector is equipped with multiple HDMI ports, RGB inputs, and composite video connections, making it compatible with a wide range of devices, including laptops, DVD players, and gaming consoles. Its compatibility with wireless presentation systems also allows for hassle-free connections, enabling users to present without being tethered by cables.

The projector features a long lamp life of up to 5,000 hours in standard mode and up to 10,000 hours in eco mode. This longevity minimizes maintenance needs and reduces total cost of ownership, making it a cost-effective investment. Moreover, its eco-friendly features, including energy-saving modes, contribute to lower power consumption, aligning with sustainable practices.

With a weight of approximately 11.5 pounds, the Hitachi CP-S860W is portable enough for easy transportation between locations, while robust enough for permanent installation. Its user-friendly interface and intuitive remote control facilitate seamless operation, ensuring an efficient setup process for any presentation.

In summary, the Hitachi CP-S860W projector combines high brightness, versatile connectivity, and advanced image processing technologies, making it a powerful tool for delivering engaging and impactful visual presentations in any environment.
Top Page Image Contents