Hitachi SJ-FB manual Setting the DIP Switches, Switch Initial Settings

Page 16

5.1 Setting the DIP Switches

Layout of SJ-FB

SWENC
	SWR
TM1	TM2

Chapter 5 SETTING

How to Set Switches SWENC and SWR [ON/OFF]

	O			1


	F			2
	F			2

Slide to the (OFF) marked side of the switch to turn it off and the opposite side to turn it on.

Figure 5-1 Switch arrangement figure

5.2 Switch Initial Settings

	Setting	Switch		Contents
	item	No.		Contents
	item	No.
			ON	Detection of disconnected	A	or	B	signal	(EAP-EAN	or
		1	ON	EBP-EBN) is valid.
				EBP-EBN) is valid.
	SWENC		OFF	Detection of disconnected	A	or	B	signal	(EAP-EAN	or
				Detection of disconnected	A	or	B	signal	(EAP-EAN	or
				EBP-EBN) is invalid.
				EBP-EBN) is invalid.
		2	ON	Detection of disconnected Z signal (EZP-EZN) is valid.
		2	OFF	Detection of disconnected Z signal (EZP-EZN) is invalid.
			OFF	Detection of disconnected Z signal (EZP-EZN) is invalid.
			ON	Termination resistance is provided between SAP and SAN
		1	ON	(150 ohms).
		1		(150 ohms).
	SWR		OFF	No terminal resistance is provided between SAP and SAN.
	SWR	2	ON	Termination resistance is provided between SBP and SBN
				Termination resistance is provided between SBP and SBN
				(150 ohms).
				(150 ohms).
			OFF	No terminal resistance is provided between SBP and SBN.

(Note) : Default setting for all the switches is OFF.

16

Image 16

Contents SJ-FB Feed-Back Board Safety Definitions and SymbolsPage Revision History Table P l a c e me n t . B e f o r e Page Contents Inquiries and Warranty WarrantyWarranty period of the board is shown below Inspection upon unpackingLocal Hitachi Distributor Outline of SJ-FB FunctionHow to Mount the SJ-FB Board Terminal Assignments of the SJ-FB Board Outlook of SJ-FB Function Explanation of the Terminals SAPTerminal wiring Terminal ConnectionsEAP EAN EBP EBN EZP EZN Setting the DIP Switches Switch Initial SettingsInverter Configuration Parameters for the SJ-FB Board Gain Setting P001 Option 21 location of specification labels Setting Flowchart for the DIP Switches Switch setting flowchartOperation Operation Orientation function Function outlineFW/RV Data setting related to speed control Data settingFeed back board of the inverter main body Control mode setting Data setting of the input-output terminalSpeed control ASR Position control APR Electronic gear functionWiring for Synchronized Operation Data setting related to position controlStat Setting example Control block diagram of the electron gear functionForward/Reverse command + pulse train mode Pulse train mode selectionForward pulse train + Reversion pulse train mode Speed control P/PI switching function Torque characteristic P/PITo restrain the speed fluctuation by the temperature change That shows it below. This thermistor is the characteristicAction selection in case of option error Causes and Countermeasures for Option Board ErrorsProtection Function Product specification N t r o l