Muting
Turning the volume control knob completely
Controls on the Subwoofer
Treble
Bass
Bass - Turn the knob marked Bass clockwise to increase the subwoofer level or counterclockwise to decrease the subwoofer level.
Treble – Turn the knob marked Treble clockwise to increase the treble level or counterclockwise to decrease the treble level.
Troubleshooting
SYMPTOM | POSSIBLE PROBLEM | SOLUTION | NOTE |
|
|
|
|
No sound from Speakers | No power to unit. | Make sure wall power | Check green power LED on |
|
| outlet or power strip has | the sub. Are the LED’s on? |
|
| power. Make sure all | If the sub’s led is not on, |
|
| switches for outlet/power | power is not getting to your |
|
| strip are on and that all | speaker system. Try the |
|
| switches for speaker | solutions shown. |
|
| system are on. |
|
| Is the control/right satellite of | Ensure that the control | There is an LED located in |
| your INVADER plugged in | speaker connector is | the bottom of each of the |
| correctly? | pushed in properly. | two satellite speakers. |
|
| Remove the control /right | These should both be lit. If |
|
| speaker connector from | they are, your speakers are |
|
| the subwoofer, then re- | both plugged in correctly. |
|
| connect this cable |
|
|
| ensuring that the |
|
|
| connector is pushed in |
|
|
| properly. |
|
|
|
|
|
Distortion (static, crackling | Noise may be caused by | Turn monitor off to see if |
|
or hissing sounds) | interference from the | noise is eliminated. Move |
|
| monitor. | speaker cables farther |
|
|
| away from monitor. |
|
| Speaker is being overdriven | Ensure that speaker is |
|
| by an amplified audio | connected to the |
|
| source. | appropriate receptacle. |
|
|
| Check |
|
|
| connectors when making |
|
|
| connections. Make sure |
|
|
| that all signal cables are |
|
|
| inserted snugly into |
|
|
| receptacles. |
|
| Volume level on sound card | Check volume of sound |
|
| may be too high. | card via Windows Volume |
|
|
| Control. |
|
| Sound card or audio source | Check speakers with | Disconnect speaker input |
| material may be cause of | another audio source. | cable (green connector) |
| problem. |
| from sound card and plug |
|
|
| into CD ROM headphone |
|
|
| jack. If static is eliminated, |
|
|
| troubleshoot the soundcard. |
Document Number: | Description: MANUAL, JBL 4.1, All languages |
Revision: 06 |
|