| Check the speaker control | Set each of the two knobs |
|
| settings. | (treble, bass level) on front |
|
|
| of the subwoofer back the |
|
|
| their center /nominal |
|
|
| positions. |
|
|
|
|
|
Too much bass or treble. | Bass/Treble level is set too | Turn Bass/Treble down or |
|
| high | return their settings to the |
|
|
| center position. |
|
|
|
|
|
Subwoofer emits a loud | Input cables not plugged in | Check input cable |
|
hum or buzzing noise. | properly | connection |
|
|
|
|
|
Speaker system | Input cable may be picking | Wrap up excess input |
|
experiences radio | up interference | cable in order to make as |
|
frequency interference or |
| short as possible |
|
picks up a radio station |
| Purchase a ferrite clamp |
|
|
| and attach over input |
|
|
| cable. A clamp can be |
|
|
| purchased at your local |
|
|
| electronics store |
|
|
|
|
|
SPECIFICATIONS
Manufacturer | Harman Multimedia | |
Model | JBL INVADER | |
Drivers (satellite) | Phoenix SE |
|
Drivers (subwoofer) | One 6 inch Magnum woofer | |
Power (satellite) | 12 watts per satellite at 1% THD | |
|
| |
Power (subwoofer) | 32 watts at 1% THD | |
Crossover Frequency (subwoofer) | 150 Hz |
|
|
|
|
Dimensions |
|
|
Width: |
|
|
Satellite | 3.0 inches | 75mm |
Subwoofer | 7.5 inches | 190mm |
Depth: |
|
|
Satellite | 4.0 inches | 100mm |
Subwoofer | 9.0 inches | 225mm |
Height: |
|
|
Satellite | 9.5 inches | 240mm |
Subwoofer | 12 inches | 300mm |
|
|
|
Input Impedance | >5k Ohm |
|
>85dB |
| |
Frequency Response | 40 – 20 kHz |
|
Input Sensitivity | 400 mV rms for rated power output | |
USA/Canada Power | 120 volts, 60Hz AC | |
Maximum Power Consumption | 120 watts |
|
UL/CUL/CE Approved |
|
|
Regulatory
FCC Statement and Warning
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
a)
b)Increase the separation between the equipment and receiver.
c)Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
d)Consult the dealer or an experienced radio/TV technician for help.
MODIFICATIONS NOT EXPRESSLY APPROVED BY THE MANUFACTURER COULD VOID THE USER AUTHORITY TO OPERATE THE EQUIPMENT UNDER FCC RULES.
Document Number: | Description: MANUAL, JBL 4.1, All languages |
Revision: 06 |
|