JBL SCS135P Tr o u b l e s h o o t i n g, System Power Control to proceed, Press Mute Button c

Tr o u b l e s h o o t i n g

Processor Reset

In the rare case where the receiver’s operation or the displays seem abnormal, the cause may involve the erratic operation of the system’s memory or microprocessor.

To correct this problem, first unplug the unit from the AC wall outlet and wait at least three minutes. After the pause, reconnect the AC power cord and check the unit’s operation. If the system still malfunctions, a system reset may clear the problem.

To clear the receiver’s entire system memory including tuner presets, output level settings, delay times and speaker configuration data, first put the unit in Standby by pressing the System

Power Control Button 2. Next, press and hold the Tone Mode 6 and the FM Mode Selector @ buttons for three seconds.

The unit will turn on automatically and display the RESET message in the Main Information Display U.

NOTE: Resetting the processor will erase any configuration settings you have made for speak- ers, output levels, surround modes and digital input assignments, as well as the tuner presets. After a reset, the unit will be returned to the factory presets, and all settings for these items must be reentered.

If the system is still operating incorrectly, there may have been an electronic discharge or severe AC line interference that has corrupted the memory or microprocessor.

If these steps do not solve the problem, consult an authorized JBL service center.

In the event that you forget the password for the DVD600II, you may reset it to the factory default by following this procedure: In Standby

mode, press the Search Reverse and

Skip Forward buttons on the front panel simultaneously for more than 3 seconds. The

Information Display will light, and a test pattern will appear on your TV. Press the

System Power Control to proceed.

SYMPTOM PROBABLE CAUSE SOLUTION

DCR600II does not function when Main • No AC Power Power Switch is pushed

•Make certain AC power cord is plugged into a live outlet.

•Check to see whether outlet is switch-controlled.

DVD600II does not turn on		• Main Power Switch turned off			• Press in Main Power Switch.
		• No AC power			• Check AC power plug and make certain any switched
					outlet is turned on.
Display lights, but no	sound	• Intermittent input connections			• Make certain that all input and speaker connections
					are secure.
		• Mute is on			• Press Mute Button c.
		• Volume control is down			• Turn up volume control.
Unit turns on, but front	panel	• Display brightness is turned off			• Follow the instructions in the Display Brightness section
display does not light	up				so that the display is set to VFD FULL.
No sound from any speaker;		• Amplifier is in Protection mode			• Check speaker wire connections for shorts at receiver and
light around power switch is red		due to possible short			speaker ends.
		• Amplifier is in	Protection	mode	• Contact your local JBL service center.
		due to internal	problems
No sound from any speaker		• No audio signal	is being transmitted		• Check that DCR600II is on and a source is playing.
		to the speakers			• Check all wires and connections between the DCR600II
					and speakers. Make sure all wires are connected. Make sure
					none of the speaker wires are frayed, cut or punctured.
					• Review proper operation of the DCR600II.
		• If in DVD mode, make sure that			• Check Input assignment for DVD Input. DVD Input should be
		analog input is not accidentally assigned			set to COAX 1 and the DVD600II Digital	Output should be
					connected to Coaxial 1 Digital Input ™	on the DCR600II.
		• Intermittent connections			• Check all audio connections.
		• Incorrect digital audio selection			• Check digital audio settings.
		• DVD disc is in Fast or Slow mode			• There is no audio playback on DVD discs	during
					Fast or Slow modes.

66