Epson EMP-800UG, ELP-811, ELP-600, ELP-800UG Using the Remote Control and Remote Operating Range

Before Using the Remote Control

Using the Remote Control and Remote Operating Range

Using the Remote Control

The remote control is used in the following way.

Procedure

1 Set the R/C switch on the remote control to the ON position.

2 Point the remote control transmitter toward one of the remote control receivers on the projector and operate the remote control buttons.

Remote control	Remote control
receiver (front)	receiver (back)

Tip :

•Do not allow sunlight or light from fluorescent lamps to shine directly onto the projector's remote control receivers, otherwise it may interfere with the reception of signals from the remote control.

•Set the R/C switch on the remote control to the OFF position when not using the remote control. Leaving the R/C switch on will consume battery power.

Remote Operating Range

Use the remote control within the ranges indicated below. If the distance or angle between the remote control and the remote control receiver is outside the normal operating range, the remote control may not work.

Operating distance	Operating angle
Approx. 10 m (30 ft.)	Approx. ±30 °	horizontally
	Approx. ±15	° vertically

14