Epson EMP-810UG, ELP-811, ELP-600 No images appear Messages do appear, Not Supported is, Displayed

Troubleshooting

No images appear (Messages do appear)

	• Check the mode which corresponds to the frequency
	of the image signals being output from the computer.
	Refer to the documentation provided with your computer
	for details on changing the resolution and frequency of the
	image signals being output from the computer. (P.106)
	• Does the input signal match the connected source?
	Use the Comp1 Input or Comp2/YCbCr Input command
"Not Supported" is
displayed.	in the Setting menu to select the signal format that matches
	the connected source.
	For Comp1: Digital-RGB,Analog-RGB,RGB-Video
	For Comp2: Analog-RGB,RGB-Video,YCbCr,YPbPr
	(P.70)

•Are the cables connected correctly?

(P.19 – 33)

•Has the correct video input port been selected?

Press the [Computer/YCbCr] or [Video] button on the projector's control panel or the [Comp1], [Comp2/YCbCr], [Video] or [S-Video] button on the remote control to

"No-Signal." is displayed. change the image source. (P.38)

•Is the power for the computer or video source turned on?

(P.37)

•If a laptop computer or a computer with a LCD screen has been connected to the projector, it is necessary to output the video signals to the projector rather than to the screen.

Normally video signals are output to only the computer's LCD screen, so you need to change the output to an external destination. For some computer models, when the image signals are output externally, they no longer appear on the LCD screen. For details, refer to the section of the documentation provided with your computer under a heading such as "External output", "Connecting an external monitor" or similar. (P.38)

84