Adjusting the Image Quality
•If you press the [Auto] button while the
•Sometimes the signals may not be adjusted correctly depending on the type of signals being output by the computer. In such cases, use the configuration menu commands to adjust the tracking and sync settings manually. (p.38, 39)
Adjusting the Tracking
If vertical stripes appear in the projected images, and this cannot be fixed using automatic setup, you will need to adjust the tracking manually using the following procedure.
Procedure
1 Press the [Menu] button on the remote control, and then select "Tracking" from the "Video" menu.
For details on this operation, refer to "Using the Configuration Menus". (p.56)
Video |
| Position |
| Adjust |
| |
Audio |
| Tracking | : | 0000 |
|
|
Setting |
| Sync . | : | 0 |
|
|
Advanced |
| Brightness | : | 0 | - | + |
About |
| Contrast | : | 0 | - | + |
Reset All |
| Sharpness | : | 0 | - | + |
|
| Color Mode |
| Select [Normal | ] | |
|
| Input Signal : | RGB | YUV( YCbCr | YPbPr) | |
|
| Auto Setup : | ON | OFF |
| |
|
| Reset |
|
| Execute |
|
: Return | : Select | : Adjust |
|
|
|
|
2 Press the [] and [] buttons to set the tracking value.
The tracking value increases or decreases each time a button is pressed.
Video |
| Position |
| Adjust |
|
|
| ||||
Audio | Tracking | : 1000 |
|
|
|
|
|
|
| ||
Setting | Sync . | : | 0 |
|
|
|
|
|
|
| |
Advanced | Brightness | : | 0 |
|
|
|
|
| + |
| |
|
|
|
|
|
|
|
|
|
|
|
|
About | Contrast | : | 0 |
|
|
|
|
|
|
| |
| - |
|
|
| + |
| |||||
Reset All | Sharpness | : | 0 |
|
|
|
|
| + |
| |
|
| Color Mode |
| Select [Normal | ] | ||||||
|
| Input Signal : | RGB | YUV( YCbCr | YPbPr) | ||||||
|
| Auto Setup : | ON | OFF |
|
|
| ||||
|
| Reset |
|
| Execute |
|
|
|
: Return: Select : Adjust
3 After making the adjustment, press the [Menu] button to exit the configuration menu.
Tip :
The image will flash when continuous tracking adjustment is carried out, but this is normal.
38