Epson 52 manual When Having Some Trouble, World-Wide Warranty Terms

When Having Some Trouble

(Warning) Indicator

		: lit	: flashing
Status	Cause	Remedy or Status		See
				Page
Red	High internal	The lamp will turn off automatically and
	temperature	projection will stop. Wait for about 5 minutes
	(overheating)	without operating the projector. After about 5
		minutes have elapsed, unplug the power cable
		and then check the following two points.
		• Check that the air inlet and air outlet are		p.16
		clear, and that the projector is not positioned
		against a wall.		p.73
		• If the air filter is dirty, it should be cleaned.
		When the power cable is plugged back in, the
		projector will return to its previous state, so
		press the [Power] button on either the
		projector's control panel or the remote control
		to turn it back on. If the projector continues to
		overheat even after the above points have been
		checked, or if the indicators show a problem
		when the power is turned back on, stop using
		the projector, disconnect the power cable from
		the electrical outlet, and contact your dealer or
		the nearest address provided at "International
		Warranty Conditions" in Safety Instructions/
		World-Wide Warranty Terms.
Red	Problem with	Disconnect the power cable from the electrical
	lamp	outlet and then remove the lamp and check if it
(0.5-		is broken. If the lamp is not broken, reinstall it.
		Then reconnect the power cable and press the
second
		[Power] button on either the projector's control
intervals)		panel or the remote control to turn the power
		back on.		p.76
		If the indicators still show a problem, stop
		using the projector, disconnect the power cable
		from the electrical outlet, and contact your
		dealer or the nearest address provided at
		"International Warranty Conditions" in Safety
		Instructions/World-Wide Warranty Terms.

62