When the Indicators Provide No Help
•Are the image signal format settings correct?
If a computer, component video or RGB video source is connected to the projector, use the "Input Signal" command in the "Video" menu to select the signal format which
matches the signal connected source. (p.47, 49)
If a composite video or
Only part of the image is displayed (Large/small)
Only part of the image is displayed
Small
•Is the [Zoom] button setting correct?
Use the [Zoom] button to adjust the size of the image. (p.33)
•Has the "Aspect Ratio" setting been selected correctly?
Use the "Aspect Ratio" command in the "Video" menu to set the aspect ratio to "4:3". (p.49)
•Is the
Press the [ESC] button on the remote control to cancel E- Zoom. (p.45)
•Has the "Position" setting been adjusted correctly?
Use the "Position" command in the "Video" menu to adjust. (p.47, 48)
•Has the correct resolution been selected?
Set the computer so that the signals that are output are compatible with this projector. Refer to the documentation provided with your computer for details on changing the settings. (p.86)
•Change the resolution for the laptop computer or computer with a LCD screen.
Change the resolution so that the image is displayed in the whole of the projection area, or set the image signal to external output only. (p.30)
•Has the computer been set for dual display?
If dual display has been activated in the Display Properties of the connected computer's Control Panel, the projector will only display about half of the image on the computer screen. To display the whole of the image on the computer screen, turn off the dual display setting. Refer to the video driver manual for the computer's monitor for further details.
67