Kodak i50, i60 manual Making connections, Locking the scanner

Page 11

Locking the scanner	1.	Make sure that the scanner is off.
	2.	Raise the document cover to reveal the flatbed platen and scanning unit.
	3.	Turn on the scanner.
		The scanning unit begins moving.
	4.	Wait until the scanning unit has moved to the end (opposite the scanner ADF).
	5.	Turn the scanner off after the scanning unit has finished moving.
	6.	Place the scanner in an upright position on its front.
	7.	Lock the scanner by moving the shipping switch (located on the bottom of the
		scanner) to the locked position.
	8.	Place the scanner back in its normal position.

Making connections

Connect the power cord and SCSI signal cable as shown below.

NOTE: There are two SCSI ports on the scanner. You can use either a DB25 (male) or a 50-pin Amphenol connector to connect to the scanner.

SCSI ports

Power switch

Power cord

To SCSI device B

SCSI cable connector

To power outlet

To PC SCSI port

6	A-61182 October 2001

Image 11

Contents User’s Guide Contents Making the most of your scanned images Requirements and software installationScanning your documents Lock scale Information Specifications MaintenanceTroubleshooting Introduction Acoustic emission SafetySafety and regulatory agency approvals For Japan Electromagnetic compliance statementsFor the United States ADF automatic document feeder Scanning specificationsAcceptable paper sizes Document types to avoid in the ADFUnlocking the scanner InstallationPrecautions Shipping switchLocking the scanner Making connectionsScsi interface device ID Setting the Scsi terminatorADF tray Adjusting the traysTurning on the scanner Turning off the scanner Powering up the scannerOutput tray Installing the scanner drivers Requirements and software installationLoading documents Using the ADFUsing the flatbed Scanning your documentsSelect your Kodak scanner model Scanning with Twain or IsisChoose Select Source or Select Scanner on the File menu Scan Method Making the most of your scanned imagesImage Type Tips ResolutionScanner Settings Application Resolution dpiBrightness Contrast Invert Mirror Preview Auto-Area Paper Size Units Enhancing your imagesAuto Level Descreen Sharpen Color AdjustmentAdvanced Settings Highlight / Shadow Color Balance CurvesHue Saturation Lightness Tip Color Drop-outUsing a scan settings file Custom SettingsScan Settings Saving a scan settings fileConfiguration Settings Width Height Size Lock scale Information Other toolsExit Starting the final scanPreview Zoom View Scan Twain Cleaning the glass scanning areas MaintenanceCleaning the ADF Replacing the ADF snap-in feed module Solution TroubleshootingProblem Color image quality is not acceptable Catalog Number Getting service Equipment disposal Scanner suppliesSpecifications Document