Chapter 4
Troubleshooting
This chapter list the POST error indicators and BIOS beep codes, as well general troubleshooting instructions.
POST Error Indicators
When a system error is detected during POST (Power On Self Text), the Setup Utility will switch to diagnostic mode and will either:
•Displays a POST error message, or
•Emits a series of beep codes
POST Error Messages
POST error messages tell users what failure the system has detected. Some error messages could be related to a hardware device. Others may indicate a problem with a device configuration. In some cases an error message may include recommendations for troubleshooting or require that you press the Enter key to display recommendations. Follow the instructions on the screen. It is recommended that you correct the error before proceeding, even if the computer appears to boot successfully.
The table below lists the messages that the BIOS has defined and can display.
If your system displays one of the messages marked below with an asterisk (*), write down the code and message and contact your Acer service provider.
IMPORTANT: If your system fails after you make changes in the Setup menus, reboot the computer, enter Setup again and load Setup defaults to correct the error.
Error Messages |
| Check or do the following in sequence: |
|
| |
Stuck Key | See “Keyboard or Auxiliary Input Device Check” section on | |
| page 63. | |
System CMOS checksum bad - Default | • | RTC battery |
configuration used | • | Run the BIOS Setup Utility to reconfigure the system time, |
|
| then reboot system. |
Real time clock error | • | RTC battery |
| • Run the BIOS Setup Utility to reconfigure system time, then | |
|
| reboot system. |
| • | Mainboard |
|
|
|
Previous boot incomplete - Default | • | Select “Load Setup Defaults” in the BIOS Setup Utility’s Exit |
configuration used |
| menu. |
| • | RTC battery |
| • | Mainboard |
|
|
|
Invalid System Configuration Data | • | Select “Load Setup Defaults” in the BIOS Setup Utility’s Exit |
|
| menu. |
| • | Mainboard |
|
|
|
Operating system not found | • | Run the BIOS Setup Utility to check if the fixed disk and drive |
|
| A are properly identified. |
| • | Optical disc drive |
| • | Hard disk drive |
| • | Mainboard |
|
|
|
Acer Aspire 4732Z/4332 Service Guide | 57 |
