Replacement of a defective lamp
WARNING:
Before pulling out the lamp module, switch off the projector and unplug the mains lead first!
For lamp replacement let the module cool down before touching the lamp and the surrounding area. Do not place the hot lampmodule on heat sensitive surfaces. Glass may shatter. Wear gloves. Keep glass covered.
Do not touch the small bulb or the mirror surface! If you accidentally get finger prints on them, remove marks with a soft cloth moistened with rubbing alcohol.
Replacement of a defective lamp is very easy with your EKTAPRO Slide Projector:
1. | 4. |
|
3.
Guarantee
Kodak gives you a one year guarantee on the original projector (without accessories and lamp) provided the projectors have been serviced regularly.
Cleaning the projector
WARNING:
For safety, always turn the machine off, unplug the mains lead and allow theprojectortocooldownbefore cleaning.
Housing:
Wipe the housing with a soft, cotton cloth and use a cleaner designed for plastic ma- terials. Do not use solvents or spirit based cleaners.
Optics:
Do not touch optical surfaces!
Clean the lens with a soft lintfree cloth or with special lens tissues.
Never wipe over a dry surface!
2.
1.Press down and hold down the lamp module release (8) and...
2.... pull out the lamp module (6).
.Push the lamp ejector lever down so that it clears the retaining clip.
Note:
For your projection requirements you have a choice of 3 lamps with different brightness and lamp life (see Accesso- ries page 22).
3.Push the ejector lever completely to the side.
The defective lamp will come free of it’s holder.
4.Remove the defective lamp and in- sert the new lamp.
.Push the ejector lever back to the right and press down until it locks into its hold- ing.
.Push the lamp module back into the projector until it locks.
Use a special lens cleaner (available from photographic dealers) or add moisture by breathing over the parts to be cleaned.
21