Kodak EKTAPRO Operation, Slide changing, Changing the slide tray in zero position

Operation

Slide changing

Using the buttons on the projector or remote control

Single Movement:

Press button (1)

forwards backwards

Quick search and zero positioning:

To transport the tray quickly in either direction, press and hold

down the slide change button-backwards (3) [ ] until the

position wanted is reached. The tray will, however, automatically stop at 0 and will remain in this position. If you want to repeat the search run, press the slide change button-backwards again.

Changing the slide tray (in zero position)

Always lift off the slide tray in the zero position!

Move tray to zero position:

a)Using the slide change button on your projector or remote control units

Hold the slide transport-backwardsbutton down. The slide tray goes into rapid search and stops automatically in the zero position.

b)Using the IR Remote Control

Select "0" on the keypad and confirm with "*". The slide tray moves to the zero position.

c) Using the mains switch

Turn the projector off by the mains switch (10). When the projec- tor is turned on again, it will complete a system check and bring the slide tray back to the zero position!

Removing the slide tray (in any position)

In an emergency, e.g. transport failure,	2.	• First switch off your projector!
the tray can be removed from the projec-

tor in any position:	1.Push aside and hold the slide tray
1.
	lock (18) while -
	2. - lifting off the slide tray.
	3.Having removed the slide tray turn
	it over and rotate the base plate until it
	locks into the zero-position, otherwise
	the slide tray cannot be replaced on the
	projector in the zero position.
	.Turn the projector on again. The
	slide remaining in the slide gate will be
	ejected by the slide lift and can be re-
	placed in the slide tray.

3.

19