Important Safety Precautions
When using your equipment, basic safety precautions should always be followed, including the following:
1.Read and understand all instructions before using.
2.Always use the correct voltage, as described on page 16. Incorrect voltage can lead to malfunctions in the projector.
3.Close supervision is necessary when any appliance is used by or near children, or others who may not understand the need for the following precautions. Do not leave the projector unattend- ed while in use.
4.Care must be taken as burns can occur from touching hot parts. For lamp replacement let the module cool down before touching the lamp and the surrounding area. Do not place the lampmodule on heat sensitive surfaces (s. p. 21).
5.Do not operate projector with a damaged cord or if the projector has been dropped or damaged - until it has been examined by a qualified service technician.
6.Position the cord so that it will not be tripped over, pulled, or placed in contact with hot surfaces.
7.If an extension cord is necessary, a cord with a current rating at least equal to that of the projector should be used. Cords rated for less amperage than the projector may overheat.
8.Always unplug the projector from the mains before cleaning and servicing (e.g. lamp replacement) and when not in use. Never pull cord to plug from outlet. Grasp plug and pull to disconnect.
9.Let the projector cool completely before putting away.
10.The element of a hot projector lamp is
11.To reduce the risk of electric shock, do not immerse this projector in water or other liquids.
12.To reduce the risk of electric shock, do not disassemble this projector, but take it to a qualified service technican if service or repair work is required. Incorrect reassembly can cause an electric shock when the projector is used subsequently.
13.The use of an accessory attachment not recommended by the manufacturer may cause a risk of fire, electric shock, or injury to persons. Only devices with
14.Connect this projector to a grounded outlet.
15.Keep air inlet (1) and air outlet (7) free from obstruction.
SAVE THESE INSTRUCTIONS!
english
15