Technical Data

Projector Measurements (see page 88):

Length:340mm

Width:336mm

Height:140mm

Height with tray: 175 mm

Weight without tray: approx. 9000 g

Weight of tray without slides: 540 g

Slide Formats:

24x36mm

4 x 4 (superslide) with special condenser

Slide Trays:

KODAKEKTAPRO80SlideTrayforhold- ing 80 slides with a maximum slide mount thickness of 3.2 mm.

SlideGate:

Gravity-feed slide change with register- gate pressure levers in two planes.

LensMount:

Universal lens mount for both spiral- and rack-mounted lenses (such as KODAK Projection FF Lenses).

Height Setting:

Height setting to a maximum of 10o via two turnable feet.

Levelling:

The projector may be operated at an angle of plus or minus 30o from the horizontal along the projector axis.

Note: Tilting the projector side ways will adversely affect the lamp lifetime!

Housing:

Sturdy,fibre-glassreinforcedhousing (LEX- AN).

All parts are marked and therefore fully recyclable.

All important structural elements for the optical equipment such as slide gate, lamp module and base for the lens mount hous- ing are in die-cast zinc assemblies.

NoiseDevelopment: approx. 57 dB (A)

Illumination

Extra Bright Lamp Module with 82V/70h/ 300W halogen lamp with integrated cold light reflecting mirror.

ProjectionLamps (available as accessories): EXR82V/35h/300W Brightness 100%

FHS82V/70h300W Brightness 80% EXY82V/200h250W Brightness 60%

Temperature range for safe operation

The operating temperature range of the projector depends on the ambient temper- ature and the voltage.

Minimum0o Candmaximum+30o C

Should the projector overheat, e.g., due to lack of cooling air, the built-in thermal cut- out automatically switches the lamp off and then switches it on again once it has cooled down.

PowerVoltage:ACONLY!

Different power voltages are adjustable via the removable fuse link.

(120,220,230,240V)

Frequency: 50/60Hz

Performance:

approximately 380 W

Fuses:

Primarycircuit:

1 x T 2A L/250V for 220, 230 and 240V or 1 x 4 A slow blow/250V for 120V

SupplyVoltageforExternalUnits: Provisionof12V/50mA(DC)directvoltage on the 8-pin remote control socket.

Slide Change Time:

1sec (independent of mains voltage and frequency).

Slide Access Times :

<5 sec for the longest search run.

8-pin Standard Projector Socket:

(For connecting the KODAK EKTAPRO Remote Systems or KODAK EKTAPRO Twin Socket Adapter).

Pin 1: 12 VDC		7
Pin 2: Gnd		7
Pin 2: Gnd	8	6
Pin 3: Signal 1 (LSB)	8	6


Pin 4: Signal 2	5	3
Pin 5: Signal 3	5	3
Pin 5: Signal 3
Pin 6: Signal 4	4
Pin 7: Signal 5 (MSB)		2 1
Pin 8: Interrupt

Control via contacts is also possible: Please note:

Pin 8 must always be connected with pin 2!

Slide transport forwards: connect pin 7 with pin 2 Slide transport reverse: connect pin 6 with pin 2 Focus forwards: connect pin 5 with pin 2 Focus backwards: connect pin 4 with pin 2

KODAK and EKTAPRO are registered trademarks.