Kodak 9200 manual Blank prints, etc, Select All-in-one printer , then Paper jam

Troubleshooting

Problem	Possible Solutions
Carriage jam	• Open the printer access door and clear any obstructions.
	• Check that the printhead and ink cartridges are installed
	correctly. (The printhead and ink cartridges are installed
	correctly when you hear them click into place.)
Print quality	• For best results, use KODAK Paper or a paper with the
	COLORLOK Technology logo on the package.
	• Make sure the paper is loaded correctly (see page 17).
	For more information, go to www.kodak.com/go/stepbystep,
	select All-in-one printer, then Print Quality (missing colors,
	blank prints, etc).
Ink cartridge	• Check that KODAK Ink Cartridge(s) are installed. Do not
	use non-Kodak brand or refilled ink cartridges.
	• Remove, then install the cartridges again. Make sure the
	cartridges click into place.
Paper jam	• Press down on the center latch on the duplexer on the back
	of the printer, open the duplexer cover, and gently remove
	any paper from inside the duplexer; close the duplexer
	cover.
	• Press the side detents on the duplexer, and remove the
	duplexer to access the cleanout area; remove any paper or
	debris, then replace the duplexer.
	• Make sure the paper in the tray is free of tears or creases.
	• Make sure you do not overload the paper tray.
	• Make sure that your is on a flat, hard surface free of debris.
	When adding paper to the paper tray, objects that are
	under the printer can enter the bottom opening and create
	obstructions.
	For more information, go to www.kodak.com/go/stepbystep.
	Select All-in-one printer, then Paper jam.

78 www.kodak.com/go/aiosupport