90%,
!
The power supply is protected against Open Circuits, Short Circuits, Overloads and Arcs
"
500A/102A/152A are approved to UL2601 and TUV
#
Meets requirements of IEC
All Remote Control Functions meet requirements of IEC
When High Voltage is enabled by using either the "HV Enable" Line or deactivation of the "Inhibit" Line the power supply will reach normal operation mode (and therefore all other published specifications) within 50 ms.
Detachable 8 feet (2.4 meters) HV Cable (see Table 2.1)
15 pin 'D' plug mating control connector
Operating Manual
2.23.1SUFFIX
Parallel Operation
2.23.2SUFFIX
Optional external fit on filter which reduces conducted
2.23.3 SUFFIX
"Low Inhibit" - A +10 to 15 volt (high) signal will allow power supply operation. A 0 to +1.5 volt (low) signal will inhibit the supply.
Revision G | |
2 - 3 | Specifications |