Jameco Electronics Superpro Series manual Run Program, Read

Page 15

Figure 15. Run

Program

The function writes the data from the buffer into the chip. The Verify function is performed automatically after programming. If an error occurs, the error message will be displayed along with the addresses and data of the chip and buffer where the error occurred. Any other result will be displayed in the message section. The current address is incremented in the Current Address display window while the chip is being programmed or verified.

Read

The function reads the content of the chip into the buffer. After reading is complete, checksum of the data will be displayed at the lower-left corner of the screen. If the chip selected is either a PLD or GAL, blow count will be shown instead of the checksum. When a GAL is programmed, the sub-device should be specified correctly.

For PROM or MCU devices, the data between the chip start address and end address will be read into the buffer.

If the chip is protected or secured, data read will be incorrect or shown as blank.

Page 14 Page 16
Image 15
Page 14 Page 16
Contents Page User’s Guide Copyrights Contents Option Alt-O Customer Support Error MessagesAppendices Test Alt-TFollowing conventions are used in this manual Software include the following featuresProgramming hardware include the following items Guide consists of three main partsStandard package contains the following Minimum requirement is as followsRunning the Program Chips with more than 48 pins on SuperproIII Adapters with 48 pins or less on SuperproIIILoad Ctrl-O File Alt-FEdit Buffer Alt-BSave ExitSwap CopyEncryption Table RadixSearch Next1 Run Device Alt-DRead Run ProgramAuto VerifyBlank Check Data CompareEditAuto Chip EndBuff Start Buff EndWord Format Byte Even WordOdd Word New Pattern Test Alt-TDelete Pattern Edit PatternAuto Find Device SettingOptions Alt-O 4 TTL&CMOS testClick Option Auto Increment Auto Increment model dependantLoad config file Save config fileCustomer Support Xeltek Technical Support Limited Warranty Error MessagesInvalid File Type
Top Page Image Contents