Jameco Electronics Superpro Series manual Buffer Alt-B, Save, Exit, Edit

Page 11

Figure 8 Data type

2.1.2 Save

This selection will save the current data in the buffer to disk.

For E(E)PROM, BPROM or MCU device types, Save File window will pop up. Select the folder and filename to be saved under. Next, File Type dialog box will pop up for selecting file type to be saved under.

For PLD devices, the Save JED File dialogue box will pop-up to enter the file name.

2.1.3Exit

This command closes the programmer software and returns you to the control of the operating system.

2.2Buffer: <Alt-B>

The menu manages data in the buffer.

2.2.1 Edit

The selection brings up Fuse Buffer Edit window if the device type is a PLD, or Data Buffer Edit window for memory/MCU devices. The HEX/ASCII data buffer is 8 bit wide. Tab key may be used to switch between HEX and ASCII data for edit. You may edit the buffer data on the screen with the following keys:

<PageUp>

:Page up

<PageDown> :Page down

<Ctrl-PageUp>

:Move cursor to the beginning of the buffer

<Ctrl-PageDown>

:Move cursor to the end of the buffer

<Home>

:Move cursor to the beginning of the line

<End> :Move cursor to the end of the line

Page 10 Page 12
Image 11
Page 10 Page 12
Contents Page User’s Guide Copyrights Contents Option Alt-O Customer Support Error MessagesAppendices Test Alt-TFollowing conventions are used in this manual Software include the following featuresProgramming hardware include the following items Guide consists of three main partsStandard package contains the following Minimum requirement is as followsRunning the Program Chips with more than 48 pins on SuperproIII Adapters with 48 pins or less on SuperproIIILoad Ctrl-O File Alt-FEdit Buffer Alt-BSave ExitSwap CopyEncryption Table RadixSearch Next1 Run Device Alt-DRead Run ProgramAuto VerifyBlank Check Data CompareEditAuto Chip EndBuff Start Buff EndWord Format Odd Word ByteEven Word New Pattern Test Alt-TDelete Pattern Edit PatternAuto Find Device SettingOptions Alt-O 4 TTL&CMOS testClick Option Auto Increment Auto Increment model dependantCustomer Support Load config fileSave config file Xeltek Technical Support Limited Warranty Error MessagesInvalid File Type
Top Page Image Contents