Jameco Electronics Superpro Series manual Contents

Page 4

Contents

1.General Description

1.1Introduction

1.1.1What is Superpro?

1.1.2Manual Organization

1.1.3Manual Convention

1.1.4System Requirement

1.3.2Package

1.2System Setup

1.2.1Software Installation

1.2.2Hardware Installation

1.2.3Running the Program

1.2.4Communication Error message

1.2.5Device Insertion

1.3Programming Operation

1.3.2Quick Guide to Programming

1.3.3Error Messages

2.Description of Menus

2.1File: <Alt-F>

2.1.1Load

2.1.2Save

2.2Buffer: <Alt-B>

2.2.1Edit

2.2.2Encryption Table

2.2.3Vector Table

2.3Device: <Alt-D>

2.3.1Run

2.3.2EditAuto

Image 4

Contents Page User’s Guide Copyrights Contents Customer Support Error Messages AppendicesTest Alt-T Option Alt-OSoftware include the following features Programming hardware include the following itemsGuide consists of three main parts Following conventions are used in this manualMinimum requirement is as follows Standard package contains the followingRunning the Program Adapters with 48 pins or less on SuperproIII Chips with more than 48 pins on SuperproIIIFile Alt-F Load Ctrl-OBuffer Alt-B SaveExit EditCopy SwapRadix SearchNext Encryption TableDevice Alt-D 1 RunRun Program ReadVerify Blank CheckData Compare AutoChip End Buff StartBuff End EditAutoWord Format Even Word ByteOdd Word Test Alt-T New PatternEdit Pattern Delete PatternSetting Options Alt-O4 TTL&CMOS test Auto Find DeviceAuto Increment model dependant Click Option Auto IncrementSave config file Load config fileCustomer Support Xeltek Technical Support Error Messages Limited WarrantyInvalid File Type