Jameco Electronics Superpro Series manual Running the Program

Page 8

switch and observe the power LED coming on bright. Please be sure not to insert any chip onto the programmer socket at this time.

1.2.3Running the Program

Please run the main program for the programmer. If everything is set up correctly, then the main screen should come up without any error message. At this point, you may select a device and proceed with programming operation.

Figure1. Main Screen

1.2.4Communication Error Message

Communication error may occur if the PC failed to communicate with the programmer. Please check the setup again and see to it that there is no device inserted in the programmer socket.

Sometimes, the error message occurs when the programmer hardware is defective. If the problem persists please contact factory for support.

Image 8

Contents Page User’s Guide Copyrights Contents Customer Support Error Messages AppendicesTest Alt-T Option Alt-OSoftware include the following features Programming hardware include the following itemsGuide consists of three main parts Following conventions are used in this manualMinimum requirement is as follows Standard package contains the followingRunning the Program Adapters with 48 pins or less on SuperproIII Chips with more than 48 pins on SuperproIIIFile Alt-F Load Ctrl-OBuffer Alt-B SaveExit EditCopy SwapRadix SearchNext Encryption TableDevice Alt-D 1 RunRun Program ReadVerify Blank CheckData Compare AutoChip End Buff StartBuff End EditAutoWord Format Odd Word ByteEven Word Test Alt-T New PatternEdit Pattern Delete PatternSetting Options Alt-O4 TTL&CMOS test Auto Find DeviceAuto Increment model dependant Click Option Auto IncrementCustomer Support Load config fileSave config file Xeltek Technical Support Error Messages Limited WarrantyInvalid File Type