Softing Linking Device –
Manual for Configuration, Installation and Maintenance
Linking Device
1.) Enable VCR Creation
If this feature is “on” then the Linking Device establishes the VCR connection by them self. Please read in the software manual if it is necessary or not.
Some examples
Softing Configuration Tool
| Emerson AMS™ Software | |
| ||
i | Please note that the feature “Automatic VCR creation has to be enabled when the | |
tool FF_CONF is to be used for the Foundation fieldbus configuration |
2.) Enable Plug&Play
This feature makes sure that
3.) Display Blocks
This feature enables or disables the point page functionality. The use of the point page creates a lot of traffic of the
4.) Enable HSE Alarms
The Linking Device is able to use the already configured alarm VCR’s in the
5.) Link Master Functionality
In case of visitor mode it can make sense to disable the Link Master functionality. If no Link Master is available then a
6.) Visitor Mode
When the Linking Device is in visitor mode it can be connected to a running
7.) Enable Modbus
This button enables or disables Modbus TCP and RTU.
8.) Enable Modbus RTU
Modbus RTU runs over the same serial interface (RS232) which is necessary to establish an application with HSE device redundancy. To use redundancy together with Modbus TCP the feature “Modbus RTU” has to be disabled.
page 24 of 85 | V1.3 |