Jenn-Air 1892, 1300 manual Display parameters ATT?, Att?Crlf

Page 25

4.27Display parameters (ATT?)

Displays all the AT settings. The command for this is:

ATT?<CR><LF>

The modem responds with:

2, 3, 0, 010, 429.850000, XX, +00, XXX, 02, 05, 2, 020, 2, 08, 0, 0, 050, 1, 429.850000 <CR><LF>

The order of the data is: 2	baud rate
3	parity
0	format mode

010command mode guard time 429.850000 centre frequency

XX RSSI (if no received data, 1 - 10 otherwise) +00 radio channel

XXX data quality (if no received data, 66 - 256 otherwise)

02squelch

05 power

2channel step size

020test message period

2over air baud rate

08preamble blocks

0frame synch. tolerance

0invert symbol

050squelch delay

1enable/disable receive data output 429.850000 radio frequency

Note: where no data has been received to provide the data, or the command has not been enabled, X is displayed.

Hermes Operator Note

Page 25 of 32

Image 25

Contents Lattice House Baughurst Basingstoke UK RG26 5LP Specialist RF DesignsTel +44 0 118 981 Fax +44 0 118 981 Received Signal Strength Indication Rssi AT S156 Table Of ContentsHandshaking Operation During Transmit and Receive List of Tables List of FiguresIntroduction Connections & Indications RS232 ConnectorPin No Function RF Connector Power ConnectorFront Panel Indications Introduction Modem OperationRS232 Data Handling Data Transfer ModesReceive-to-Transmit Turnround Description Time msMAX Command Mode List of CommandsOkcrlf Errorcrlf Command SyntaxParity ATB1 Baud Rate AT B0AT F?CRLF Format Mode AT FOK Crlf Engineering Test Modes ATRXX, Dxxxcrlf Software Version Information AT Command Mode Guard Time AT S154ATI9CRLF Centre Radio Frequency AT S155Rssi Level Level at RF Input dBm ±2dB Data Quality AT S158 Radio Channel AT S157Squelch Level Level at RF Input Squelch AT S159Output Power for 1W G-MAX Output Power for 2W G-MAX Transmission Power AT S160Power Level Output Power DBm Tolerance Nominal Level NominalTest Message Period AT S162 Channel Step Size AT S161Preamble Period AT S165 Note engineering function only Over-Air Symbol Rate AT S163 Note engineering function onlyFrame Synch Tolerance AT S166 Note engineering function only Invert Symbol AT S167Squelch Delay AT S168 Radio Frequency AT &F Restore defaults AT &Y8Save parameters AT &W AT &WCRLFATT?CRLF Display parameters ATT?Do not enter unless you wish to carry out a code load Ppppppppppppppppppppppppppppppppppppppppppppppppppppp RS232 Port Parameters Hardware SpecificationParameter Max SXn50 Radio SpecificationsEnclosures Mechanical SpecificationFront View of Casting Operating conditions Vibration SpecificationsType Approvals EMC