Jenn-Air 1892, 1300 manual Ppppppppppppppppppppppppppppppppppppppppppppppppppppp

Page 27

A typical programming sequence display is as follows:

PPPPP...........................................................................

................................................................................

................................................................................

................................................................................

................................................................................

................................................................................

..........................................PPPPPPPPPPPPPPPPPPPPPPPPPPPPPPPPPPPPPP

PPPPPPPPPPPPPPPPPPPPPPPPPPPPPPPPPPPPPPPPPPPPPPPPPPPPP.::::

:

Flash Programming Successful!!

Hermes®, © 2001, Wood & Douglas Ltd.

Apply a DC reset to the modem before using the modem.

If an error in the data is received the modem responds with:

Flash Programming Failed!!

Hermes®, © 2001, Wood & Douglas Ltd.

If power is lost or some other problem occurs before the upload is completed, the next time the modem is powered on it automatically requests new data by outputting the above message. This repeats until the code load is successful.

Hermes Operator Note

Page 27 of 32

Image 27

Contents Specialist RF Designs Lattice House Baughurst Basingstoke UK RG26 5LPTel +44 0 118 981 Fax +44 0 118 981 Table Of Contents Received Signal Strength Indication Rssi AT S156Handshaking Operation During Transmit and Receive List of Tables List of FiguresIntroduction RS232 Connector Connections & IndicationsPin No Function Power Connector RF ConnectorFront Panel Indications Introduction Modem OperationData Transfer Modes RS232 Data HandlingReceive-to-Transmit Turnround Time ms DescriptionMAX List of Commands Command ModeOkcrlf Errorcrlf Command SyntaxParity ATB1 Baud Rate AT B0AT F?CRLF Format Mode AT FEngineering Test Modes AT OK CrlfRXX, Dxxxcrlf Centre Radio Frequency AT S155 Command Mode Guard Time AT S154Software Version Information AT ATI9CRLFRssi Level Level at RF Input dBm ±2dB Data Quality AT S158 Radio Channel AT S157Squelch Level Level at RF Input Squelch AT S159Level Nominal Transmission Power AT S160Output Power for 1W G-MAX Output Power for 2W G-MAX Power Level Output Power DBm Tolerance NominalTest Message Period AT S162 Channel Step Size AT S161Preamble Period AT S165 Note engineering function only Over-Air Symbol Rate AT S163 Note engineering function onlyFrame Synch Tolerance AT S166 Note engineering function only Invert Symbol AT S167Squelch Delay AT S168 AT &WCRLF Restore defaults AT &Y8Radio Frequency AT &F Save parameters AT &WATT?CRLF Display parameters ATT?Do not enter unless you wish to carry out a code load Ppppppppppppppppppppppppppppppppppppppppppppppppppppp RS232 Port Parameters Hardware SpecificationParameter Max SXn50 Radio SpecificationsEnclosures Mechanical SpecificationFront View of Casting EMC Vibration SpecificationsOperating conditions Type Approvals