Cleaning or Replacing the Filters
The Cineos TV has two filters that cover air inlets on the bottom of the set. Maintaining a free flow of air through the inlets is very impor- tant. If the air filters become dirty, clogged, or blocked, the temperature in the set will rise.
Should the heat level become too high due to blockage, a sensor detects this, and a warning message appears on screen alerting you to check the air inlets for blockage. The message will be displayed for 6 seconds. It reappears every 15 minutes as long as the temperature remains too high.
If the internal temperature of the TV rises to high, a warning message alerts you that the TV is shutting down. If the temperature remains at this high level for 1 minute, the TV will enter Standby mode. In Standby mode, the TV is off.
Be sure the TV is not placed on a surface (such as a shag carpet) that will prevent the free flow of air through the inlets, and periodically clean or replace the filters as detailed in the following instructions.
WARNING: Do not tip the TV when remov- ing or installing the filters. This may result in instability of the TV.
1 Place your fingers under one of the fil- ter slots located at either bottom left or right in back of the TV cabinet.
2 Grasp the filter and gently pull it straight out.
3 Examine the filter for dust or other contamination. If it is dirty, clean it with a vacuum cleaner. DO NOT WASH it. Replace the filter if vacuum- ing does not sufficiently clean it.
To order replacement filters, call the Philips Customer Care Center at
WARNING:
DO NOT operate the TV without fil- ters. This will cause serious damage to the TV.
4 Turn the filter so that the arrow is pointing toward the center of the TV. Align the edges of the filter with the slot track, then gently slide it all the way back into the slot. A click sound can be heard as the filter reaches the correct position.
INT
EXT
Locations of Air Filters
1 | INT |
EXT |
2 | INT |
| EXT |
CENTER
CENTER
3
4 | INT |
EXT | |
| TER |
| CEN |
| CENTER |
70