Philips 27964-01A Installation - Remote Connections, Scenario 5 - T-Max Manager Series with wires

Installation - Remote Connections

Scenario 4 - T-Max® Manager Series with

Wireless combo 2

Wireless can be easily added to an existing salon already utilizing T-Max®. Connect one AP-900 (with Power Injector) to the Manager and one AP-900 to each wireless ready tan- ning bed. The rest of the salon may be “daisy-chained” together and connected to the Manager.

Scenario 5 - T-Max® Manager Series with wires

As always, this tanning bed is fully com- patible with a wired T-Max® system.

Simply connect the RJ-22 modular cable(s), described in the T-Max® Manager manual, into either of the smaller remote port(s) located on the back of the canopy and follow the instructions

that came with your remote system.

Scenario 6 - Single Bed wired to T-Max® 3A

In single sunbed installations, the T-Max® 1A and 3A can offer the same control as the T-Max® Manager, eliminating the need for a Manager. If you’re using a 1A in this manner, it must have a chip labelled “master” installed on its circuit board. The remote control bypass plug must not be used in this configuration. The 3A may be used as a “master” with no modification.

After you have set the T-Max® 1A’s, or 3A’s, address to “0” (refer to your T-Max® user’s guide) and the sunbed’s address to “1”, simply connect the RJ-22 modular cables, described in the T-Max® user’s guide, directly into either of

the smaller ports located on the back of the canopy and either port on the back of the T-Max® 1A or 3A.

27964-01A

15