nstallation
Unpacking and Inspection
Your sunbed comes in two cardboard car- tons, one for the bench and one for the canopy. Open the cartons and remove the bench and canopy as follows.
The bench and canopy are each wrapped in plastic. Pull back the plastic and, with a helper, grasp the bench and pull it from the carton bottom, leaving the plastic wrap and the carton packaging. Do the same for the canopy. Do not attempt to lift either unit with the plastic still on as it may slip.
Note! The cartons are reusable. You may wish to save them for future use.
As you unpack your boxes you should find the following:
•Canopy unit
•Bench unit
•Pair of gas springs
•Front skirt panel
•Bag containing necessary assembly hardware, safety goggles, opening handle and pillow
•Gas spring cover panel
Inspect these items, including the canopy and bench, and make sure they are free from any visible damage. Report the extent of any damage to the transportation company.
Record the serial numbers of the canopy and bench in the area provided at the back of this manual. This information will be required whenever you call customer service.
Tools Required
You will need the following tools to assemble your sunbed.
Utility Knife
#2 Phillips
Screwdriver
7/16” Wrench
1