Philips 27964-01A user manual Troubleshooting, Problem, Solution, My bed is connected to a T-Max

	Troubleshooting
Problem	Solution
My bed is connected to a T-Max®	You have probably attempted to connect your sunbed to the
remote system but I am having	remote system already. Disconnect the remote plug(s) from the
trouble getting into “id” mode	ports at the back of the sunbed, wait 90 seconds and try again.
My bed, connected to a T-Max®
Manager, did not display “dL” but
does indicate:
“0”	1. Remote device has not been set.
	2. The sunbed has not been connected to the remote system, see
	Remote Connections.
a tanning time and the lamps	1. Delay time of T-Max® Manager has not been set.
have come on	2. Delay time has expired and session has begun.
a tanning time but the lamps	Auto start function of T-Max® Manager has been turned off.
have not come on	Press the timer button to turn on lamps.
When auto-addressing the first bed	When using the auto address feature of the T-Max® Manager
does not register an “id”	you must wait 10 seconds from the time you start the auto
	address function before addressing the first bed.
When using a T-Max® 1A my	SunStar® Bypass plugs or terminator plugs may be needed if
sunbed won’t function properly	the T-Max® 1A and the sunbed are over 100 feet apart. Install
	the plugs in the open remote port in the sunbed and the T-
	Max® 1A.
My salon suffers frequent, short	If you have a T-Max® Manager, changing parameter 23 from
power outages and clients com-	“0” to “1” will allow the tanning bed to remember how much
plain about losing session time	time was left when power goes out and resume its session
	after power is restored. Consult your T-Max® Manager manu-
	al for information on setting parameters.

27964-01A

26