Operation - Using Your Sunbed
Using Your Sunbed
When used as a stand alone unit or when connected to a remote system using a control relay.
A BC D E F G
AFace tanner control - Turns face tanners 1. Lift the canopy, lie down on the bench
on and off during use. Face tanner | (face up), lower the canopy toward your |
lamps require one minute to relight. | body using the canopy handle. See Safety |
(Units equipped with face tanner only) | Information for positioning instructions. |
BBody tanner control - Turns body lamps on and off during use. (Units equipped with face tanner only)
CBody fan control - Controls the speed of the body fan during use.
DBody fan speed indicator - Indicates speed of fan. (OFF - LOW - MED - HI)
ETimer display - Displays remaining time.
FStop button - Stops tanning session.
GTimer button - Turns bed on. Timer dis- play shows remaining time. If a lesser time is desired, press timer button until desired time is displayed.
WARNING
Wear protective eyewear.
Failure to may result in severe burns or longterm injury to the eyes.
2.Put on your safety goggles.
3.Press the timer button (G) to begin the tan- ning session. The lamps will turn on and the timer will begin to count down.
4.If a tanning time less than the displayed time is desired repeatedly press the timer button (G) to decrease the remaining time.
5.When the timer reaches 0 the lamps turn off. If you want to stop your session before time expires, press the stop button (F). You will have ten seconds to restart with the remaining time, otherwise the timer will reset to 0.
6.Raise the canopy by using the outer edge of the canopy, do not push up on the acrylic shield. The cooling fans run for a period of time after the lamps shut off to aid in cooling the sunbed.
19