Philips 27964-01A user manual are and Maintenance, Cleaning After Use, Thorough Periodic Cleaning

are and Maintenance

Cleaning After Use

Clean and disinfect your tanning bed’s bench and canopy after each use. Use a non-abrasive disinfectant cleaner that does not contain ammonia or ammonia deriva- tives. Ammonia may damage the acrylic shield. Spray the acrylic lightly with disin- fectant and wipe dry with a clean soft cloth. We recommend Australian Gold® pH Neutral Disinfectant Cleaner.

Thorough Periodic Cleaning

Introduction

The cooling fans draw air through the bed and over time will cause a dust buildup on the lamps and reflectors. This will reduce the tanning effectiveness of the bed. When a dust buildup is observed, it is necessary to thoroughly clean the inside of the bench and canopy.

WARNING

Shock hazard.

Disconnect power before removing any protective covers.

Step 2 With a soft cloth, wipe the entire length of each lamp to remove any film buildup.

Step 3 Clean both sides of the acrylic shields with a non-ammonia dis- infectant cleaner.

Step 4 Wipe the reflectors with a clean damp cloth.

Step 5 Re-install the lamps and acrylic shields.

Mechanical Inspection

Your tanning bed has been built for years of service. To ensure trouble-free operation throughout its life, inspect the unit’s mechanical integrity every 400-500 hours of use.

•Inspect the unit’s fasteners verifying that all are firmly in place.

•Inspect gas springs for signs of wear. Gas springs that will not hold the canopy in the full open position when raised should be immediately replaced. See Troubleshooting.

•Inspect the AC power cord and its connections.

27964-01A

Cleaning the Canopy and Bench

Step 1 Remove the acrylic shields and lamps as described in Lamp and Acrylic Replacement.

•Inspect the acrylic. Broken, cracked or badly scratched acrylics should be immediately replaced.

20