
Chapter 5: Operation of Web-based Management
5.2.7 IGMP Snooping
Function name: IGMP Snooping Configuration
Function description: IGMP Snooping lets administrators configure a switch to constrain multicast traffic by listening to Internet Group Management Protocol (IGMP). After finishing the settings, click on the “Apply” button to start up the function.
Figure 5-14. IGMP Configuration.
Parameter description:
IGMP Enabled: Just tick the check box to enable this function. The default is disable.
Router Ports: Just tick the check box beside Port x to enable router ports, then press the “Apply” button to start up. The default is none.
Unregistered IGMP Flooding enabled: Just tick the check box to enable this function. The default is enable.
VLAN ID: When IGMP Enable mode is selected, it will list the VLAN ID number.
IGMP Snooping Enabled: After the IGMP Enabled function starts up, tick the check box to enable this function. The default is enable.
IGMP Querying Enabled: After IGMP Enabled function starts up, tick the check box to enable this function. The default is enable.
5.2.8 Mirroring Configuration
Function name: Mirror Configuration
Function description: Mirror Configuration enables the switch to monitor the traffic in the network. This switch supports
Parameter description:
Source Port: Set up the port you want to monitor. Just tick the check box beside Port x. Valid ports are Port
Mirror Port: Use the
Page 56 |