Installation Requirements
Xerox FS 3270, User's Guide
1. Installation Requirements
This chapter gives you a short description of the Xerox FS 3270 and its installation requirements.
1.1. Introduction to Xerox FS 3270
The Xerox FS 3270 is a protocol converter which enables any printer (or other output device) to be connected to an IBM computer sys tem.
The printer or device should have either an RS 232/V24 serial connector, or a Centronics parallel connector in order to be con nected to the Xerox FS 3270 protocol converter.
The IBM system should use the 3270 type terminals. See Section 1.3, Supported Control Units, for information on the IBM systems to which the Xerox FS 3270 connects.
PCL or FSL output driver
The output driver selection switch on the rear panel of the box al lows you to change from PCL (factory default) to FSL if needed:
The PCL Driver (Default Driver)
If you wish to operate in PCL mode, the box is ready to operate as it is when delivered. It is important that you do not change the position of the switch. When used with certain older IBM controllers, the FSL function Y8 may have to be set to obtain the correct SCS printer language. For further programming of the box, you are referred to the Laser 3270 Programmer's Guide; D62078, subpart D62030.
The FSL Driver
To use a
- 5 -