Xerox 5000 manual Decurler Profile procedure

Page 100

3. Profiles

Decurler Profile procedure

IMPORTANT! Before using this procedure, use a Decurler A-D setting to eliminate the curl in our print output; refer to page 3-

34.If a Decurler A-D setting is unsuccessful in eliminating your curl, evaluate the curl on the output prints (page 3-36). Once you have measured and recorded the curl on your output, then you can perform this procedure.

1. Load a specific Paper Tray with the paper you wish to use

for a job. Make the correct paper selections on the Tray Properties window for the paper being used and run a few test prints.

a.If there is too much curl, save the stack and continue to the next step.

b.If the test prints are acceptable, you are finished.

NOTE: For the purpose of this procedure, Paper Tray 1 is used as the example.

2. Select one of these Decurler A-D settings from the Tray Properties window.

3. Run the same print job again, and retrieve the output from the exit area of the digital press.

3-42	DocuColor 5000 Administrator Guide

Image 100

Contents Administrator Page Table of contents Administrator overview Profiles Table of contents DocuColor 5000 Administrator Guide Symbols ConventionsConventions Safety notices Electrical safetySafety notices Disconnect device Laser safety North AmericaEurope EU Safety standards Maintenance safetyOperational safety Ozone safety Radio frequency emissions FCC in the USACanada ICES-003 Safety extra low voltage approvalRegulatory information for Rfid Certifications in Europe AL7 1HEIt’s illegal in the USA DocuColor 5000 Administrator Guide Xix It’s illegal in Canada Environmental notices for Canada Product recycling and disposal European union Other countriesXxiv DocuColor 5000 Administrator Guide Logging on as Administrator OverviewAdministrator overview Finishing System Profiles overview Administrator overview DocuColor 5000 Administrator Guide System Settings User Interface Fault Details window System Settings Change Password System Settings System Settings Setting the Date & Time System Productivity Setting Productivity charts Single Paper WeightMixed Paper Weight Power Saver Exit Power Saver Auto Resume AfterFault Clearance Pause Job Spacing Auto Logoff NVM Read/Write Drilled PapersSystem Settings System Settings System Settings Choose the default settings for the following options Tray OptionsSystem Settings Paper Tray Assist System Settings System Settings Tray Priority Profiles Alignment Profiles Alignment Adjustment Profile procedure Next Creating an Alignment profile Creating an Alignment profile Selecting the Registration options Selecting the Perpendicularity options Selecting the Skew options Selecting the Magnification options Running test prints Next Editing an existing Alignment profile Editing an existing Alignment profile Custom Paper Custom Paper procedure Creating an Custom Paper profile Selecting the desired paper type Selecting the desired paper weight Selecting other options for your Custom Paper profile Profiles Profiles Profiles Next Running test prints Running test prints Editing a Custom Paper profile Second Bias Transfer Belt No Mottle Profiles Profiles Aligner Roll Pressure Paper Tray Air Assist Decurler OverviewDecurler specifications Decurler settings A-D Decurler A-D procedure Evaluate your print output for paper curl Upward DownwardProfiles Decurler Profile options Name Downward/Upward Values ExampleProfiles Decurler Profile procedure Profiles Profiles Profiles Profiles Profiles Profiles DocuColor 5000 Administrator Guide