Xerox 5000 manual Profiles

Page 80

3. Profiles

TIP: The default setting for both Sides 1 and 2 is 100%. It is recommended that you leave this option at its default setting until you run test prints and evaluate the output of the prints. Test Print is discussed in more detail in Running test prints.

NOTE: Refer to page 3-26for information on the 2nd Bias Transfer Belt.

14. If required, choose an Aligner Roll Pressure setting.

TIP: The default setting is 0. It is recommended that you leave this option at its default setting until you run test prints and evaluate the output of the prints. Test Print is discussed in more detail in Running test prints.

NOTE: Refer to page 3-30for information on the Aligner Roll Pressure.

3-22	DocuColor 5000 Administrator Guide

Image 80

Contents Administrator Page Table of contents Administrator overview Profiles Table of contents DocuColor 5000 Administrator Guide Symbols ConventionsConventions Safety notices Electrical safetySafety notices Disconnect device Laser safety North AmericaEurope EU Safety standards Maintenance safetyOperational safety Ozone safety Radio frequency emissions FCC in the USARegulatory information for Rfid Safety extra low voltage approvalCanada ICES-003 Certifications in Europe AL7 1HEIt’s illegal in the USA DocuColor 5000 Administrator Guide Xix It’s illegal in Canada Environmental notices for Canada Product recycling and disposal European union Other countriesXxiv DocuColor 5000 Administrator Guide Logging on as Administrator OverviewAdministrator overview Finishing System Profiles overview Administrator overview DocuColor 5000 Administrator Guide System Settings User Interface Fault Details window System Settings Change Password System Settings System Settings Setting the Date & Time System Productivity Setting Productivity charts Single Paper WeightMixed Paper Weight Power Saver Exit Power Saver Auto Resume AfterFault Clearance Pause Job Spacing Auto Logoff NVM Read/Write Drilled PapersSystem Settings System Settings System Settings Choose the default settings for the following options Tray OptionsSystem Settings Paper Tray Assist System Settings System Settings Tray Priority Profiles Alignment Profiles Alignment Adjustment Profile procedure Next Creating an Alignment profile Creating an Alignment profile Selecting the Registration options Selecting the Perpendicularity options Selecting the Skew options Selecting the Magnification options Running test prints Next Editing an existing Alignment profile Editing an existing Alignment profile Custom Paper Custom Paper procedure Creating an Custom Paper profile Selecting the desired paper type Selecting the desired paper weight Selecting other options for your Custom Paper profile Profiles Profiles Profiles Next Running test prints Running test prints Editing a Custom Paper profile Second Bias Transfer Belt No Mottle Profiles Profiles Aligner Roll Pressure Paper Tray Air Assist Decurler OverviewDecurler specifications Decurler settings A-D Decurler A-D procedure Evaluate your print output for paper curl Upward DownwardProfiles Decurler Profile options Name Downward/Upward Values ExampleProfiles Decurler Profile procedure Profiles Profiles Profiles Profiles Profiles Profiles DocuColor 5000 Administrator Guide