Xerox 5000 manual Second Bias Transfer Belt

Page 84

3. Profiles

Second Bias Transfer Belt

The Second Bias Transfer Belt is where the image is transferred from the belt to the paper. The Second Bias Transfer Belt feature

is normally used with heavier weight paper, such as 220 g/m2 and greater, 10 pt, or 12 pt, which are just three examples; however there are times when it is also used with lighter weight paper as well.

When using either heavier or lighter weight paper, you may want or need to adjust Side 1 for all 1-sided jobs. If defects continually occur in a printed job when using heavier weight paper, perform the following steps to determine if a Custom Paper Profile with Side 1 or Side 2 (2nd Bias Transfer Belt) adjustments are appropriate.

1. If the job is printed face down or 1-N, check Side 1 for

defects on the topside (upper portion) of the stacked sheets, and check Side 2 for defects on the downside (lower portion) of the stacked sheets.

2. If the job is printed face up or N-1, check Side 2 for defects

on the topside (upper portion) of the stacked sheets, and check Side 1 for the downside (lower portion) of the stacked sheets.

3-26	DocuColor 5000 Administrator Guide

Image 84

Contents Administrator Page Table of contents Administrator overview Profiles Table of contents DocuColor 5000 Administrator Guide Symbols ConventionsConventions Safety notices Electrical safetySafety notices Disconnect device Laser safety North AmericaEurope EU Safety standards Maintenance safetyOperational safety Ozone safety Radio frequency emissions FCC in the USASafety extra low voltage approval Canada ICES-003Regulatory information for Rfid Certifications in Europe AL7 1HEIt’s illegal in the USA DocuColor 5000 Administrator Guide Xix It’s illegal in Canada Environmental notices for Canada Product recycling and disposal European union Other countriesXxiv DocuColor 5000 Administrator Guide Logging on as Administrator OverviewAdministrator overview Finishing System Profiles overview Administrator overview DocuColor 5000 Administrator Guide System Settings User Interface Fault Details window System Settings Change Password System Settings System Settings Setting the Date & Time System Productivity Setting Productivity charts Single Paper WeightMixed Paper Weight Power Saver Exit Power Saver Auto Resume AfterFault Clearance Pause Job Spacing Auto Logoff NVM Read/Write Drilled PapersSystem Settings System Settings System Settings Choose the default settings for the following options Tray OptionsSystem Settings Paper Tray Assist System Settings System Settings Tray Priority Profiles Alignment Profiles Alignment Adjustment Profile procedure Next Creating an Alignment profile Creating an Alignment profile Selecting the Registration options Selecting the Perpendicularity options Selecting the Skew options Selecting the Magnification options Running test prints Next Editing an existing Alignment profile Editing an existing Alignment profile Custom Paper Custom Paper procedure Creating an Custom Paper profile Selecting the desired paper type Selecting the desired paper weight Selecting other options for your Custom Paper profile Profiles Profiles Profiles Next Running test prints Running test prints Editing a Custom Paper profile Second Bias Transfer Belt No Mottle Profiles Profiles Aligner Roll Pressure Paper Tray Air Assist Decurler OverviewDecurler specifications Decurler settings A-D Decurler A-D procedure Evaluate your print output for paper curl Upward DownwardProfiles Decurler Profile options Name Downward/Upward Values ExampleProfiles Decurler Profile procedure Profiles Profiles Profiles Profiles Profiles Profiles DocuColor 5000 Administrator Guide