Xerox 5000 manual Profiles

Page 61

3. Profiles

When creating Alignment Profiles for Side 1 and/or Side 2 prints, be aware of the following:

•Side 1/Side 2 images may be misregistered because the paper is not the exact same size. It may vary slightly, with differences of plus or minus 1mm, causing the image to be misregistered. To reduce the possibility of size differences, it is recommended that you use paper from the same lot when running duplex jobs.

•During the fusing process, the heat and pressure applied to the paper causes the paper to stretch. If the images on Sides 1 and 2 are the same size, the stretching of the paper may cause the image on Side 1 to be slightly larger than the image on Side 2.

•Creating an Alignment Profile for these types of jobs allows you to reduce or eliminate the images being larger on Side1 than on Side 2 prints.

NOTE 1: Your Alignment Profile may or may not be affiliated with a Custom Paper Profile.

NOTE 2: Once an Alignment Profile is set and in use, your color server will not reflect that profile in the print options for print jobs.

NOTE 3: After an Alignment Profile is set, it remains active until you reenter Administrator mode and switch it off. If an active Alignment Profile is not associated with a Custom Paper Profile, it is used for each paper tray to which it is assigned.

DocuColor 5000 Administrator Guide

3-3

Image 61

Contents Administrator Page Table of contents Administrator overview Profiles Table of contents DocuColor 5000 Administrator Guide Conventions SymbolsConventions Electrical safety Safety noticesSafety notices Disconnect device North America Laser safetyEurope EU Maintenance safety Safety standardsOperational safety Ozone safety FCC in the USA Radio frequency emissionsCanada ICES-003 Safety extra low voltage approvalRegulatory information for Rfid AL7 1HE Certifications in EuropeIt’s illegal in the USA DocuColor 5000 Administrator Guide Xix It’s illegal in Canada Environmental notices for Canada Product recycling and disposal Other countries European unionXxiv DocuColor 5000 Administrator Guide Overview Logging on as AdministratorAdministrator overview Finishing System Profiles overview Administrator overview DocuColor 5000 Administrator Guide System Settings User Interface Fault Details window System Settings Change Password System Settings System Settings Setting the Date & Time System Productivity Setting Single Paper Weight Productivity chartsMixed Paper Weight Power Saver Auto Resume After Exit Power SaverFault Clearance Pause Job Spacing Auto Logoff Drilled Papers NVM Read/WriteSystem Settings System Settings System Settings Tray Options Choose the default settings for the following optionsSystem Settings Paper Tray Assist System Settings System Settings Tray Priority Profiles Alignment Profiles Alignment Adjustment Profile procedure Next Creating an Alignment profile Creating an Alignment profile Selecting the Registration options Selecting the Perpendicularity options Selecting the Skew options Selecting the Magnification options Running test prints Next Editing an existing Alignment profile Editing an existing Alignment profile Custom Paper Custom Paper procedure Creating an Custom Paper profile Selecting the desired paper type Selecting the desired paper weight Selecting other options for your Custom Paper profile Profiles Profiles Profiles Next Running test prints Running test prints Editing a Custom Paper profile Second Bias Transfer Belt No Mottle Profiles Profiles Aligner Roll Pressure Paper Tray Air Assist Overview DecurlerDecurler specifications Decurler settings A-D Decurler A-D procedure Upward Downward Evaluate your print output for paper curlProfiles Decurler Profile options Name Example Downward/Upward ValuesProfiles Decurler Profile procedure Profiles Profiles Profiles Profiles Profiles Profiles DocuColor 5000 Administrator Guide