Xerox 5000 manual Next Editing an existing Alignment profile

Page 70

3. Profiles

e.Select Start. The UI displays this message after the test prints are printed:

f.Retrieve your prints.

g.Discard the first few prints, as inconsistency tends to be greater with these images.

19.Evaluate the test prints by holding your 2 Sided output at

eye level near a light source. This will allow you to see the registration marks for both Side 1 and Side 2 of the output.

a.If you determine that the registration between Side 1 and Side 2 is unacceptable and needs adjusting, repeat this procedure starting at Selecting the Registration options.

TIP: You may need to repeat this procedure numerous times until you achieve acceptable output prints.

b.If the printed output for both Sides 1 and 2 is acceptable, select OK to save and close the Profiles window.

NOTE: Once you have selected OK to save and close the Profiles window, the new profile procedure (for example, AlignmentProfile2) can be selected from the Tray Properties window whenever you want to run a job using this profile.

20. Next: Editing an existing Alignment profile.

3-12	DocuColor 5000 Administrator Guide

Image 70

Contents Administrator Page Table of contents Administrator overview Profiles Table of contents DocuColor 5000 Administrator Guide Symbols ConventionsConventions Safety notices Electrical safetySafety notices Disconnect device Laser safety North AmericaEurope EU Safety standards Maintenance safetyOperational safety Ozone safety Radio frequency emissions FCC in the USACanada ICES-003 Safety extra low voltage approvalRegulatory information for Rfid Certifications in Europe AL7 1HEIt’s illegal in the USA DocuColor 5000 Administrator Guide Xix It’s illegal in Canada Environmental notices for Canada Product recycling and disposal European union Other countriesXxiv DocuColor 5000 Administrator Guide Logging on as Administrator OverviewAdministrator overview Finishing System Profiles overview Administrator overview DocuColor 5000 Administrator Guide System Settings User Interface Fault Details window System Settings Change Password System Settings System Settings Setting the Date & Time System Productivity Setting Productivity charts Single Paper WeightMixed Paper Weight Power Saver Exit Power Saver Auto Resume AfterFault Clearance Pause Job Spacing Auto Logoff NVM Read/Write Drilled PapersSystem Settings System Settings System Settings Choose the default settings for the following options Tray OptionsSystem Settings Paper Tray Assist System Settings System Settings Tray Priority Profiles Alignment Profiles Alignment Adjustment Profile procedure Next Creating an Alignment profile Creating an Alignment profile Selecting the Registration options Selecting the Perpendicularity options Selecting the Skew options Selecting the Magnification options Running test prints Next Editing an existing Alignment profile Editing an existing Alignment profile Custom Paper Custom Paper procedure Creating an Custom Paper profile Selecting the desired paper type Selecting the desired paper weight Selecting other options for your Custom Paper profile Profiles Profiles Profiles Next Running test prints Running test prints Editing a Custom Paper profile Second Bias Transfer Belt No Mottle Profiles Profiles Aligner Roll Pressure Paper Tray Air Assist Decurler OverviewDecurler specifications Decurler settings A-D Decurler A-D procedure Evaluate your print output for paper curl Upward DownwardProfiles Decurler Profile options Name Downward/Upward Values ExampleProfiles Decurler Profile procedure Profiles Profiles Profiles Profiles Profiles Profiles DocuColor 5000 Administrator Guide